What is the repair manual for a Yamaha Virago?
Also identified in this Yamaha Virago service repair manual is Euro-style chain-drive and shaft driven models. STARTER TROUBLESHOOTING 1.1 Table 1-1. Starter Does Not Run or Runs At Very Low Speeds
What are the symptoms of a faulty Yamaha Virago starter?
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
How to do an oil change on a Yamaha 750?
Location of middle gear drain plug (11.6 ft-lb), filter (11ft-lb), and main oil drain (31 ft-lb). Fill 2.65 Liters of 10W/30 or 20W/40 if you are riding above 41°F and you drain the filter, main, and middle gear. Hope this helps. Loading…
Where is the middle gear drain plug on a 1982 Maxim?
1982 Yamaha 750 Maxim Oil Change with middle gear drain plug location. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
What should I do about my Yamaha Virago 750?
The XV-700’s and 750’s require a different repair because they do not have the starter clutch. Yamaha suggests changing the large tension clip, P/N 904-68291-06-00, on the idler gear. Look for wear in the clip groove. Hand grind smooth. Replace the idler gear also. A dealer would use a spring gauge to check the tension of the spring clip.
Is the starter on a Yamaha Virago defective?
The Virago is no different than any other motorcycle manufacturer when it comes to having defects in design or manufacturing. In Yamaha’s case, it is the starter employed by the Virago that has become the primary complaint.
Where is the compression spring on a Yamaha Virago?
Replace the idler gear compression spring, P/N 905-01156-36-00, and starter gear tension clip, P/N 904-68291-14-00. These parts are located inside the left side cover. Yamaha does not recommend welding the starter ring gear because if the engine should backfire you could do serious damage to the case.
Can You welding the starter on a virago?
Yamaha does not recommend welding the starter ring gear because if the engine should backfire you could do serious damage to the case. I know that this method of repair worked for many club members, but if locking-in the ring gear was a design requirement, I’m sure that Yamaha would have avoided this flaw.