How to adjust torque on a polo head?
Light/Dark Mode Enabled: You can now select the option by clicking the moon/lightbulb in the top right corner! Tighten in that order in 3 stages (ie all to stage 1, then all to stage 2, then all to stage 3) Bolts are stretch type, so should not be reused (some books say you can reuse them once, but I wouldn’t).
Which is the maximum torque for a bolt?
Recommended Maximum Bolt Loads and Torque Values (Metric CoarseThreads) 3.6 5.6 6.9 8.8 10.9 12.9 A/F mm Newtons N.m Newtons N.m Newtons N.m Newtons N.m Newtons N.m Newtons N.m mm
Do You under stand in Ibiza Ingles 05.14?
(05.14) (GT9) Ibiza Inglés (05.14) SEAT S.A. is permanently concerned about continuous development of its types and models. For this reason we ask you to under- stand, that at any given time, changes regarding shape, equipment and technique may take place on the car delivered.
How to repair a Volkswagen Polo Mk5 power unit?
Open spring-type clips and pull coolant hoses -1- and -2- off. Push catch -3- underneath coolant hoses and pull hoses upwards. Put down coolant hoses to rear. Remove thermostat housing from cylinder head. Unbolt engine side of assembly mounting from above -arrows-. Remove assembly mounting and unscrew engine support. Unbolt earth wire -1-.
How to adjust camshaft in Volkswagen Polo Mk5?
Hold camshaft sprocket with counterhold tool -T10172-. Then turn crankshaft 1 / 4 revolution (90°) back counter to direction of engine rotation. Turning crankshaft opposite to normal direction of rotation prevents damage to valves when camshaft is subsequently adjusted. Turn camshaft until grooves -arrows- are in position shown.
How to install intake manifold on Volkswagen Polo Mk5?
Removing and installing intake manifold → Chapter. Push 2 spindles with hooks onto support bracket -10 – 222 A-. Fit support bracket -10 – 222 A- with adapter -10 – 222 A /8- as shown. Position adapter -10 – 222 A /8- on vehicle front end -arrows- as shown. Hook in hooks at left lifting eye.