Do you need to replace the front CV joint on a Mercedes?
Replacing a Mercedes CV boot or CV joint requires the removal of the front axle. As tightening torque values vary both on the model and yearly basis, it is best to verify by calling the dealer. In most cases, you will need a 27mm hex nut socket. However, some models might have a larger 32mm nut, so that you will need a 32mm bi-hex socket.
How do you remove the center axle from a Mercedes Benz?
While the car is still on the ground, remove the center cap with the Mercedes-Benz logo from the wheel. This will expose the center axle shaft bolt. (Shown with the wheel removed.) Using a breaker bar and an appropriate socket, break loose and partially unbolt the center axle shaft bolt.
How much does it cost to replace CV joints?
Cv joints are not particularly expensive items to buy and can range from as little as £20 up to roughly £150. Depending on the car, the labour charge to fit them shouldn’t be that much either. Bank on half an hour to an hour per side to replace.
Where is the retaining ring on a CV joint?
Most CV joints should have a retaining ring at the end of the inner CV joint spline. You will need to rotate the half shaft until the tabs on the case align with grooves on retaining rings. Usually, there are no markings, so you have to try until you get it right.
What is the CV boot on a Yamaha Grizzly?
NOTE: The front CV boot sets for the Yamaha Grizzly are slightly different from one another. The CV boot set (double offset joint) is for the outer CV joint while the CV boot set (ball joint) is for the inner CV joint. Step 1. Remove the front wheel and the central dust cap beneath it.
How do you remove a circlip from a CV joint?
Wipe away the old grease from the half shaft and CV joint, and remove the circlip from the end of the half shaft. Step 16. Pack the inner CV joint with grease, and slide a new inner CV boot down the half shaft and into the channel in the CV joint. Slide the smaller end of the CV boot into the channel on the half shaft.
When to replace cotter pins on Yamaha Grizzly?
Torque the lower ball joint nut to 22 foot-pounds and the upper ball joint nut to 18 foot-pounds. Replace the cotter pins in the upper and lower ball joints.
What’s the difference between CV boot and ball joint?
The CV boot set (double offset joint) is for the outer CV joint while the CV boot set (ball joint) is for the inner CV joint. Step 1. Remove the front wheel and the central dust cap beneath it.