What do you need to know about a Yamaha Grizzly 125?
Set the switch to the “HI” position to turn on the high beam and the taillight. Check the operation of the throttle lever before you start the engine. If it does not work smoothly, check for the cause. 1. Throttle lever Correct the problem before riding the ATV. Consult a Yamaha dealer if you can’t find or solve the problem yourself.
Where is the fuel screw on a Yamaha Grizzly?
One type is called a fuel screw because it regulates the flow of fuel into the idle circuit. This type of screw is located ahead of the carbs slide tower (motor side) and is most often found under the carbs bore and upside-down directly ahead of the carbs float bowl.
How can I find out if my Grizzly 125 is safe?
FOR MORE INFORMATION ABOUT ATV SAFETY, call the Consumer Products Safety Commission at 1-800-638-2772, or the ATV Distributor’s Safety Hotline at 1-800-852-5344. Page 18 q WARNING Otherwise, fuel may leak out of the carbu- retor or fuel tank.
How does the slides jet needle work on a grizzly ATV?
Once you have your rich stumble, back off one size at a time until full throttle operation results in normal operation. (Note: If your ATV runs faster at 3/4 throttle than full throttle you are definitely lean on the main!) The slides jet needle controls 1/4-3/4 throttle. It does this by passing upward through the needle jet.
Why does my Yamaha Grizzly stall at low rpm?
I have a 2008 700 eps, keeps stalling at low rpm or just when i touch the trotle. I have a k&n air filter and pipe tip. Also some one told me to buy a odyssey battery (pc545) still didn’t fix the problem. There is only 240km on the machine, didn’t bring it back to yammaha yet for its first service. Anybody have any coments.
What does 89 octane do to a Yamaha Grizzly?
We have had two 07’s with that problem and it seems like running 89 octane helped with the stalling problem, Yamaha replaced the gas tank breather, rollover valve but that did not seem to help anything and I believe they replaced it with one off of an 08.
One type is called a fuel screw because it regulates the flow of fuel into the idle circuit. This type of screw is located ahead of the carbs slide tower (motor side) and is most often found under the carbs bore and upside-down directly ahead of the carbs float bowl.
Why does my Grizzly Ides engine not start?
The fuel venting system is blocked..this could be from the tank or elswhere…look for pipes that vent from the carb direct…try running the engine with the fuel tank cap off after it has stalled. As to the pilot jet setting… as a general guide only… 1 1/2 turns out is a good start.