Why are my handle bars loose on my Harley Davidson?
Each handle bar clamp sits on top of a 1 inch spacer and its this assemby that is loose. I check the manual and the bike for a bolt to tighten and came up blank. Do I have to remove the handle bar clamps to get to this bolt ??
What to do if your handle bars are loose?
Discussion in ‘ Wheels ‘ started by dangerdan, Jul 15, 2009 . Handle bars appear to be loose. With little effort I can wiggle the hand grips back and forth about an inch. Manual says to remove the inner fairing to get at the handle bar clamp screws. Wow, thats quite labour intensive. Can this job be done by only removing the front fairing.
Why are my handle bars loose on my Springer?
All the factory bikes have rubber mounted risers that have some play in them so the bars will move a bit. That’s the first I have heard of that about the springers having more play. Check the riser bolts under the top triple tree and make sure they are tight.
What kind of handlebars do I need for a 09 RCK?
I need advice I rode a 09 RCK yesterday from the dealer about 150 miles to my home and was not happy about the reach to the handlebars (Stiff neck) by the time I got home. Here is my question On this site there are several posts regarding HD part # 56902-08 Heritage Softail handlebars that are a direct replacement for the Road King.
Each handle bar clamp sits on top of a 1 inch spacer and its this assemby that is loose. I check the manual and the bike for a bolt to tighten and came up blank. Do I have to remove the handle bar clamps to get to this bolt ??
Discussion in ‘ Wheels ‘ started by dangerdan, Jul 15, 2009 . Handle bars appear to be loose. With little effort I can wiggle the hand grips back and forth about an inch. Manual says to remove the inner fairing to get at the handle bar clamp screws. Wow, thats quite labour intensive. Can this job be done by only removing the front fairing.
All the factory bikes have rubber mounted risers that have some play in them so the bars will move a bit. That’s the first I have heard of that about the springers having more play. Check the riser bolts under the top triple tree and make sure they are tight.
How much does it cost to change handlebars on a Harley Davidson?
The dealer says that Labor would be $142.00 plus $105.00 for a Twist Grip Sensor that is reccomanded when changing all handlebars. I think that this can be done wihtout replacing the Twist Grip Sensor. Should I attempt to due this on my own? Any advice would be appreciated.
Where are the Torx screws for the front fairing?
Remove two (2) torx screws, which are located just slightly low right of the speaker, at both sides. Com’on you can find it You don’t need to remove any wind deflectors, and/or any lower fairing. Take your time. Remove the two (2) torx screws, which are located, kinda hidden, behind the forks.
How can I adjust my front handle bar?
Front the front panel, you can see the two (2) hex screws that hold the handle bar; loose these two screws, and adjust the handle bar to your comfort position. Take your time, because you don’t want to scratch the front plastic panel.
Remove two (2) torx screws, which are located just slightly low right of the speaker, at both sides. Com’on you can find it You don’t need to remove any wind deflectors, and/or any lower fairing. Take your time. Remove the two (2) torx screws, which are located, kinda hidden, behind the forks.
Front the front panel, you can see the two (2) hex screws that hold the handle bar; loose these two screws, and adjust the handle bar to your comfort position. Take your time, because you don’t want to scratch the front plastic panel.