How to change drive belt and clutch pulley on wheel?
An error occurred while retrieving sharing information. Please try again later. Project Why Not….. Foot Down Fun
When to change the drive belt on a tractor?
Watch Before You Change Husqvarna Drive Belt! – Tractor Transmission Belt Slipping Problem SOLVED! – YouTube
How to change main transmission drive belt on Kohler Magnum lawn mower?
This video shows how to replace the main automatic transmission drive belt on a Sears Craftsman Kohler Magnum lawn tractor mower with an electric clutch. Model 917.256711. Please make sure you disconnect your battery and have the gas drained before flipping your mower on its side. Some motors cannot be turned on their sides.
Where is the clutch cable on a lawn mower?
1 ADJUSTING THE TENSION ON THE CLUTCH CABLE The clutch cable leads from the clutch lever, and goes down the handle and into the deck of the mower. The clutch lever may be either: •The small vertical lever on the RIGHT of the main handle (when viewed from behind), or •The bar running ACROSS and BELOW the main handle at the top, or
How do you remove the drive belt from a lawn mower?
Lower the mower deck to the lowest cutting position. Remove the left pulley cover from the mower deck. Push in the blade belt idler pulley and roll the blade drive belt off the left blade pulley. Reach under the rear of the mower frame and remove the blade drive belt from the electric clutch.
How do you change a ground drive belt?
Route the new ground drive belt over the cooling fans and onto the transmission pulleys. Thread the belt through the idler pulley and over the engine crankshaft pulley. Have your helper push in the idler pulley bracket while you roll the belt onto the engine pulley.
How do you remove a drive clutch on a golf cart?
Using an air gun, remove the center bolt and centering washer from the drive clutch. Once out, you’ll notice that the bolt is much smaller than the hole from which it came out.
How do you change the drive belt on a Kawasaki Teryx?
Pull the nut off and slide your crowbar out. As you slide your primary clutch off, there are going to be two washers. Set those aside, making sure not to lose those. Now you can pull your primary and secondary clutch out at the same time. Remove the belt. [5:02] When inspecting your clutches, look for any excess belt dust.
What kind of pulleys do you use for a drive belt?
These pulleys are cast iron. Choose from nylon, UHMW, and zinc. A built -in spring maintains tension on your belt. Increase efficiency, vary speed, and extend the life of your drive by changing the pitch on these pulleys.
Do you have to change pulleys on a Harley Davidson?
Also, if the belt is in good shape, take your time and see whats best. If you go too drastic with pulley changes, you might really regret that as you might all but kill your low end, especially if your going to do any two-up with even a lttle bit of luggage.
How big is the pulley on a Harley Davidson?
Some pleasure cruising, all my buds have bigger motors & 6 spds. When I change the belt, I am thinking of changing the front pulley from a 32t to a 34t and the rear pulley from a 70t to a 65t…