What are the torque settings for polo Bah motor big ends?
– Fit remaining cylinder head bolts and tighten hand-tight. – Tighten all bolts to 30 Nm. – Then tighten all bolts a 1//4 turn (90 °) further using a rigid wrench. – Then tighten all bolts again a 1/4 turn (90 °) further.
What’s the problem with the VW Polo 1.6?
Hello, VW polos 1.0, 1.4. 1.6, suffer from carbon bulid up in the throttle bodys causing bad idling, esp the Bosch Mono-Motronic (Throttle Body Injection systems), a good clean with carb cleaner should repair the problem, also engine temp sensor replacement and idle speed control valve replacement can help idle problems.
How to tighten cylinder head on polo Bah?
– Then tighten all bolts a 1//4 turn (90 °) further using a rigid wrench. – Then tighten all bolts again a 1/4 turn (90 °) further. There is no requirement to retighten the cylinder head bolts after repairs.
How to keep polo Bah motor from leaking?
Damaging will lead to leaks. – Place a clean cloth in cylinders so that no dirt or emery cloth particles can get in between cylinder wall and piston. – Also prevent dirt and emery cloth particles from getting into the coolant. – Carefully clean cylinder head and cylinder block sealing surfaces.
– Fit remaining cylinder head bolts and tighten hand-tight. – Tighten all bolts to 30 Nm. – Then tighten all bolts a 1//4 turn (90 °) further using a rigid wrench. – Then tighten all bolts again a 1/4 turn (90 °) further.
How to adjust torque on a polo head?
Light/Dark Mode Enabled: You can now select the option by clicking the moon/lightbulb in the top right corner! Tighten in that order in 3 stages (ie all to stage 1, then all to stage 2, then all to stage 3) Bolts are stretch type, so should not be reused (some books say you can reuse them once, but I wouldn’t).
Hello, VW polos 1.0, 1.4. 1.6, suffer from carbon bulid up in the throttle bodys causing bad idling, esp the Bosch Mono-Motronic (Throttle Body Injection systems), a good clean with carb cleaner should repair the problem, also engine temp sensor replacement and idle speed control valve replacement can help idle problems.
– Then tighten all bolts a 1//4 turn (90 °) further using a rigid wrench. – Then tighten all bolts again a 1/4 turn (90 °) further. There is no requirement to retighten the cylinder head bolts after repairs.
How big is the cylinder head of a Volkswagen Polo?
Clicking this will make more experts see the question and we will remind you when it gets answered. You can’t post conmments that contain an email address. cylinder head-30-35 nm + 30-35 + 65deg + 65deg. You can’t post conmments that contain an email address.