What kind of crankshaft does Arctic Cat have?
ARCTIC CAT WILDCAT 700cc TRAIL XT/LTD ENGINE BEARING CRANKSHAFT-B 4PCS! ARCTIC CAT WILDCAT 700cc TRAIL XT/LTD ENGINE PISTONS 2PCS! Parts Shipped Fast, Free and Easy with Boss Bearing!
Can a 1993 Artic cat 700 EFI shut off?
There is a special washer on the top and bottom of the under the throttle lever. These can wear out (every year) and the throttle will rock and the ignition will cut out or even shut off. If you hold the throttle lever with one hand so the pin can move in and out against the switch and open the throttle, it should shut off the motor.
What kind of engine does Arctic Cat Wildcat have?
ARCTIC CAT WILDCAT 700cc TRAIL XT/LTD ENGINE INLET + EXHAUST CAMSHAFTS 2PCS! 09-18 Arctic Cat 550 H1 / 700 H1 Bottom End Crankcase Engine Cases – SEE NOTES! ARCTIC CAT WILDCAT 700cc TRAIL XT/LTD ENGINE PISTON’ PINS + GIFT 2 C-PINS! ARCTIC CAT WILDCAT 700cc TRAIL XT/LTD ENGINE BEARING CRANKSHAFT-A 4PCS!
What’s the fuel pressure on a 1993 Arctic Cat?
1993 Artic Cat 700 EFI… 1993 Artic Cat 700 EFI (wild cat). Runs normal for 10 minutes. Starts losing RPM’s. If i stay on the throttle or increase throttle it will shut down. If i let go of the throttle it will idle ok with extra smoke. Checked throttle position sensor checks ok. Fuel pressure is 36lbs.
There is a special washer on the top and bottom of the under the throttle lever. These can wear out (every year) and the throttle will rock and the ignition will cut out or even shut off. If you hold the throttle lever with one hand so the pin can move in and out against the switch and open the throttle, it should shut off the motor.
1993 Artic Cat 700 EFI… 1993 Artic Cat 700 EFI (wild cat). Runs normal for 10 minutes. Starts losing RPM’s. If i stay on the throttle or increase throttle it will shut down. If i let go of the throttle it will idle ok with extra smoke. Checked throttle position sensor checks ok. Fuel pressure is 36lbs.
Where is the safety switch on an Arctic Cat?
The connector for the safety switch is under the handlebar pad. There is a three pin connector. You can unplug this and jump the two wires for the safety switch on the harness side, or on some models you can cover the center pin and plug it back together. The two wires do jumper are the center brown and the B/W.