Why is my Harley clicking noise?
When you turn the key and the battery is dead, you hear the magnet trying to magnetize the gear which is what makes the clicking sound. If the battery doesn’t give enough power, that magnet doesn’t have enough power to turn the flywheel of the engine.
When did I replace the battery on my Street Glide?
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
Why is my Harley Davidson Dyna Glide not starting?
If your battery voltage and connections are in good condition, but your engine is still refusing to turn over, the problem may be in the starter circuit. Perhaps the easiest place to begin is at the starter solenoid on the right side of the motorcycle.
Can a Harley Davidson HD start without a fob?
Starting your HD without a Fob! Your HD has the ability to be started without a Fob present jus in case the Fob is lost or the battery goes dead! Your Pin# to over-ride the security system is usually loaded up with the last 5 numbers of your Harley’s serial # backwards!
How to start a bike without a fob?
Here is how to use the code you jus entered to start your bike without the Fob present!! 1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window. 2. Enter the first digit of your PIN (a) by pressing the left turn signal switch (a) times.
I have a 2014 Street Glide Special with about 40k miles. I replace the main battery in February and then last week I took the bike for a ride. After stopping for a drink, the bike would not start.
Why does my Harley Davidson bike not start?
When I turn on the bike and put it in the run position, the fuel pump kicks on, but when I push the start switch the bike doesn’t even try to turn over. The battery is fully charged and the fuel pump turns on when I push the switch, but nothing else happens.
Here is how to use the code you jus entered to start your bike without the Fob present!! 1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window. 2. Enter the first digit of your PIN (a) by pressing the left turn signal switch (a) times.
How to turn off the FOB on a Harley Davidson?
Here’s how to do it!! 1. Select 5 digit code ( each digit being a 1 thru 9) and record it on the wallet card in the owners manual. 2. With an assigned FOB present, turn IGN key ON – OFF – ON – OFF – ON 3. Press Left turn signal switch 2 times. 4. Press Right turn signal switch one time and release.