What to do with a 2018 Kawasaki MULE 4010?
2018 Kaw. mule 4010 .was advised :1. clean baffle plate with throttle body cleaner 2. remove crankcase vent from intake (plug connection and vent to atmosphere).3.carefully lubricate baffle plate shaft.4.switch to non-ethanol. I have done all of this. This machine is a piece of S…!!!!
Why is my 4010 mule surging so much?
Having problems with my 4010 mule surging. This is what I have finally found was causing it. Factory recommended cleaning and then changing throttle body which solved it for 1 week. The real problem appears to be the ethanol gas. We switched to non ethanol gas and after about a month the problem went away.
Are there brakes on a Kawasaki MULE 3010?
The brakes on the 3010 were quite effective; however I spent some time on a downhill slope trying to find out if the petrol Mule disengaged its engine braking when the engine speed got down to idle. Thankfully this model Kawasaki Mule offered engine braking at all times when driving downhill, a very important feature for any ride-on ATV.
What to do when your Kawasaki MULE stalls?
Then locked the screw down. Kawasaki reccommends against doing this and says that the throttle body then has to be replaced, but if the TPS’s are adjusted properly after doing this, it seems that they idle much better if the operator is one of those guys who tends to open the throttle before turning the key on & cranking the engine.
Is there a problem with my Kawasaki MULE 4010?
I took my 2016 Mule 4010 Trans 4×4 in for 500 hour service last week. to open a gate or something. When running at half to full throttle, it was fine, but would surge and run unevenly when at low RPMs. might arise again in the future. Mule owners had returned almost immediately with the same problem. She indicated
Then locked the screw down. Kawasaki reccommends against doing this and says that the throttle body then has to be replaced, but if the TPS’s are adjusted properly after doing this, it seems that they idle much better if the operator is one of those guys who tends to open the throttle before turning the key on & cranking the engine.
Where is the throttle control on a Kawasaki MULE?
The throttle control you step on only controls the sub-throttle valve which is upstream of the main throttle valve.
What’s the base idle speed on a Kawasaki MULE?
On another Mule in testing, we opened up the sub throttle’s stop screw to achieve 800 RPM base idle speed. This was done by manually holding the sub throttle closed and then adjusting the stop screw until 800 RPM was seen on the laptop. Then locked the screw down.