What are the wires on the 92 Polaris Indy 500?

What are the wires on the 92 Polaris Indy 500?

’92 Polaris Indy 500 electrical question. Hi, I just got a 92 Indy 500 SKS and I just put a new battery in it and nothing seems to happen. It looks like I got all the wires hooked up right (3 red wires going to the positive terminal and 1 black wire from the engine going to the negative terminal).

Where are the circuit breakers on a Polaris ATV?

The circuit breakers on this four-wheeler are used instead of fuses. It is common for moisture to corrode the circuit breakers and cause similar electrical problems on these Polaris ATVs. I’ve seen quite a few people in the forums asking where these circuit breaker bags are located as well as how to test them.

What kind of battery does a Polaris snowmobile have?

You can try it, find a 95 EFI schematic, and compare it to yours, it may or may not be the same since the chassis changed in 94 or 95. I have the Clymers manual for 90-95 polaris and that seems to help lots. I do have a brown wire which comes off the battery regulator that goes to no where.

How to use an EFI engine in a snowmobile?

You can use your EFI engine you have now,you just need to drill a hole in the crankcase for the fuel pump pulse line,the hole is already there for it you just need to finish drilling it through. Then get different carb boots, and then install the mechanical fuel pump,carbs,throttle and choke cables.

’92 Polaris Indy 500 electrical question. Hi, I just got a 92 Indy 500 SKS and I just put a new battery in it and nothing seems to happen. It looks like I got all the wires hooked up right (3 red wires going to the positive terminal and 1 black wire from the engine going to the negative terminal).

You can try it, find a 95 EFI schematic, and compare it to yours, it may or may not be the same since the chassis changed in 94 or 95. I have the Clymers manual for 90-95 polaris and that seems to help lots. I do have a brown wire which comes off the battery regulator that goes to no where.

You can use your EFI engine you have now,you just need to drill a hole in the crankcase for the fuel pump pulse line,the hole is already there for it you just need to finish drilling it through. Then get different carb boots, and then install the mechanical fuel pump,carbs,throttle and choke cables.

Where does the red light go on a Polaris Indy 500?

The red with a green stripe is fed from the battery + terminal through the green fusible link and therefore should be hot at all times when you check it with your test light. If there is no power check the fuse link first because corrosion is common here.