Is the 4 wheel drive switch working on my Outlander 400XT?
I verified that the 4 wheel drive switch is good from voltage tests to the actuator connector and I could hear the actuator was working by pressing the 4 wheel drive switch with the engine not running. I pulled the actuator and I can see there is a broken pin on a part refered to as the slider in the parts breakdown.
How to fix a 2009 Outlander 800 4×4 problem?
Raise the rear end and start the bike . Engage 4wd and see if the front prop shaft will rotate with light throttle. If it does , your diff is smoked . If it doesn’t either the actuator isn’t engaging or ( like Bomb said ) your through shaft is snapped. Click to expand… Roger that, appreciate the help.
Why did my Outlander lose its 4×4 shaft?
The loss of 4×4 happened after I became EXTREMELY stuck a little while back. The old cv belt roasted and haven’t had 4×4 since. I have replaced cv belt and it moves no problem but 4×4 is a no go. Appreciate the advice and will check it out and see if the shaft came apart inside.
Why does my Honda ATV not shift gears?
ATVs with an electric shifter, like the Honda AS models, uses an electric motor to shift through the gears. If the motor does not work, the bike will not shift gears. The only way to make it shift is by using the emergency shifter (a short-shifting shaft sticking out the left lower side of the engine, use the supplied gear change tool).
I verified that the 4 wheel drive switch is good from voltage tests to the actuator connector and I could hear the actuator was working by pressing the 4 wheel drive switch with the engine not running. I pulled the actuator and I can see there is a broken pin on a part refered to as the slider in the parts breakdown.
Why is my Speedo not working on my Outlander 400?
I had a similiar problem with my 400 outlander and found it to be a broken wire very close to the black electrical actuator, once i repaired it all started working again. But now on the other hand my light indicator on the speedo cluster is not lighing up for the 4X4 like it is suppose to, but I can still hear the actuator engaging the 4X4.
Is there a problem with the 2WD / 4WD switch?
But now on the other hand my light indicator on the speedo cluster is not lighing up for the 4X4 like it is suppose to, but I can still hear the actuator engaging the 4X4. So if anybody has any Ideas on that it would be appreciated. i just get an 400 MAX XT (4/2005) and i recognized an problem with 2WD/4WD switch.
Why is my 4WD not working on my ATV?
Last night I was messing with it.. pulled the plug on the actuator to make sure it was absoulutley clean, plugged it back in, turned key on, hit the 4wd switch and it engaged.. tried it several other times and it sounded like it would hang up or “delay” before engaging or disengaging.