Can You troubleshoot a John Deere Gator 6×4?
It won’t take much time or many tools to troubleshoot your Gator 6×4 engine problems. The John Deere Gator 6×4 utility vehicle has excellent traction, stability and low impact on sensitive turf. It’s just what you need to work in the most rugged terrains.
Why is my John Deere Gator not starting?
Jumping the solenoid takes much of the wiring out of the equation and your activating the starter sorta manually. Then you say your starter is getting 7 volts. That’s a big red flag. Then you say when turning the key to the start position you hear a click.
Where does the power come from on a Gator 6×4?
The Gator™ TH 6X4’s power is transmitted from the transaxle to the center axle. The rear axle is driven by roller chains from the center axle. 1. High flotation tyres
What should the kill wire be on a John Deere Gator?
The coils kill wire should be open, not shorted to ground when the ignition switch is in the run and start position. The kill wire should be grounded when the switch is in the off position. 2. You’re saying the starter energizes with the first key switch “run” position? That again sounds like a wiring problem.
It won’t take much time or many tools to troubleshoot your Gator 6×4 engine problems. The John Deere Gator 6×4 utility vehicle has excellent traction, stability and low impact on sensitive turf. It’s just what you need to work in the most rugged terrains.
What to do if your Gator won’t start?
Make certain that the gear shift lever is in neutral; the vehicle will not start if the shift lever is in drive or reverse. Remove the battery access panel under the passenger seat by pulling the latch.
Where are the spark plugs on a John Deere Gator?
(They are located beneath the instrument panel, behind the brake pedal.) Replace any blown fuses and try starting the Gator. Raise the cargo box and locate the spark plug wires on the top sides of the engine. Wiggle the wires to see if they are loose.
How do you charge a John Deere Gator?
Remove the battery access panel. Connect a battery charger to the battery, by clamping the negative (-) charger cable to the negative battery terminal, and the positive (+) charger cable to the positive battery terminal. Plug the charger into an electrical outlet and charge the battery according to the charger instructions.