How to install the ignition coil on a Dyna s?
Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine. Install the bolt and tighten. Ensure that the rotor is still free to rotate. 7. Remove the wire that connected the points and ignition coil. 8.
Why is the rear cylinder not working on a Harley Davidson?
Start the engine. If the rear cylinder is still the only one that is working, the ECM or ignition module is the problem. But if the front cylinder now becomes the one that is working & the rear cylinder is the dead one,,, that tells you the coil is bad. This is similar to a problem a friend is having with his 2005 Springer.
What are the windings on a Harley Davidson ignition coil?
In this video Bob takes a look at the Harley Davidson ignition coil. The coil consists of two windings of wire, the primary and the secondary.
Why is the rear cylinder not working on my Springer?
If the rear cylinder is still the only one that is working, the ECM or ignition module is the problem. But if the front cylinder now becomes the one that is working & the rear cylinder is the dead one,,, that tells you the coil is bad. This is similar to a problem a friend is having with his 2005 Springer.
Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine. Install the bolt and tighten. Ensure that the rotor is still free to rotate. 7. Remove the wire that connected the points and ignition coil. 8.
What kind of wire to use for Dyna 2000i ignition?
Attach the pink wire from the tach to the 2000i green wire with the large (.250) blade connectors. If the bike had only one pink (or pink/black) wire at the coil, connect this to the 2000i green wire. Do notconnect the 2000i tach wire to the coil or damage to the ignition may result. 5.
How to connect a Dyna 2000i to a tach?
Use a test light or meter to find the white wire that has +12V when boththe key and the Run/Stop switches are on (later models have only a single white/black wire). Attach this andthe white wire from the 2000i to one of the primary terminals. Attach the pink wire from the 2000i to the other primary terminal. 4. Tach connection (if equipped).
How to install advance Assembly on Dyna’s engine?
Push the rotor down until it engages the weights on the advance assembly [it will only go on one way}. Ensure that the rotor rotates freefy·on the shaft as the advance weights move out and back. · 6. Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine.
Push the rotor down until it engages the weights on the advance assembly [it will only go on one way}. Ensure that the rotor rotates freefy·on the shaft as the advance weights move out and back. · 6. Install the advance/rotor assembly on the engine making sure the pin on the advance assembly is engaged in the slot on the engine.
How to install Split lock washer on Dyna s?
Install split lock washers on screws. Remove spark plug wires and inspect for cciroded terminals and cracked insulation. Connect an ohmmeter to each end and gently pull and twist the wire to check for breaks. Check the spark plugs. Replace if excessively fouled -do not clean. VOLTAGE TEST Rrst check the primary resistance of the ignition coils.
How to remove spark advance from Dyna s?
1. Remove the point cover. 2. Remove the two standoffs holding the point plate to the engine. Unplug the wire going to the points and remove point/plate assembly. 3. Remove the bolt holding.the spark advance assembly to the engine and remove the assembly. 4. Remove the point cam from the advance assembly. 5.