What to do when there is no error message on Balboa?
If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CFEor CONFIG ERROR below or contact your Dealer or Service Organization. The “CFE” or “CONFIG ERROR” Configuration Error Appears to have been Corrected or is Intermittent.
What to do if there is no error message on the topside panel?
Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. 2. Press any “Cool”, “Warm”, or “Temp” Button to Exit Priming Mode. 3. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is No Error Message, Select “No Error Message” Below.
What does CFE or config error mean on Balboa direct?
The “CFE” or “CONFIG ERROR” Configuration Error Appears to have been Corrected or is Intermittent. If the Error Repeats, Retest the “CFE” or “CONFIG ERROR” Configuration Error or Call Balboa Technical Service for Assistance. “Cyclic Redundancy Code” (CrC) Checksum Error.
What to do if your cyclecomputer display is blank?
Examine the terminals to see whether there is any corrosion. If the terminals look fuzzy, clean them with a cotton swab dipped in ammonia. Put in a new battery. If the display is still blank, it is time to give up unless you are handy with a soldering iron.
How can I tell if my cyclecomputer battery is failing?
Battery failure is easy to diagnose. If you see clear, black numbers on the screen, the battery is OK. As the battery weakens, the liquid-crystal display may go dim. When the battery fails, the display will go completely blank. Open up the unit and remove the battery. Examine the terminals to see whether there is any corrosion.
Why is my front wheel reading computer not working?
The usual problems occur around the headset, where the wire can be pulled too hard if the handlebar is turned farther than usual. Front-wheel reading computers should be more reliable, because when they are properly installed there are no loose loops of wire.
Is it complicated to diagnose a bike?
Diagnosing a bike is not complicated (if you’re allowed to update your phone’s firmware, why not your bike?). You should apply the concept of IoT to your e-bike products. Let the users have more freedom to choose what to do with the stuff we buy. 5- The bike diagnosis should be able to be performed also by the users.