How to troubleshoot a GY6 150cc ignition plug?
Sends a signal to the CDI to let it know when to send fire to the plug. Set your multimeter to read in VOLTS “AC”. Locate and disconnect the Black/Red and Blue/Yellow wires coming from the stator, where they plug into the main engine harness. (These are both bullet-style connectors)
Why does my Mercedes not start when I charge the battery?
This Mercedes-Benz is not starting because of a low battery. In this case, what you need to do is trickle charge your battery using any of these 12 volt battery trickle chargers. If you need help read this article on How to charge a Mercedes-Benz the right way. Mercedes won’t start, and it’s not the battery.
Why does the stator send voltage to the CDI?
Your stator creates voltage for two reasons. To send voltage to your CDI unit (power pack or switchbox) to run your engine and to send voltage to your rectifier/regulator that will charge your battery. Engines with no spark or intermittent spark on one bank can be caused by a faulty stator.
Why is my Mercedes Benz starter not working?
Often times, when the starter is defective or seizes up it will blow out the fuse that protect the starter circuit. Another thing that you can try is to hit the starter with a rubber hammer a couple of times. Depending what kind of starter problems you have, the starter may work a few more times.
Why is the crank fuse at the start position?
Could be the ignition switch faulty try a hot wire direct to the starter motor small terminal then see if it cranks You can’t post conmments that contain an email address.
Where is the fuse box on a G Class wagon?
Interior fuse box is located on the side of dash. You will find the fuse box if you look at the driver’s (left) side of dash. A plastic cover can easily be removed. Use a Dash Trim Removal Tool to avoid damaging the dashboard. Fuse Panel under armrest, Rear SAM Control Unit. Fuse and Relay Module N10/2
What kind of fuses does a Mercedes Benz use?
Your Mercedes-Benz uses Automotive Blade Fuse Type. A box of 100 fuses which include all the different ampere ratings that you need cost less than $20 on Amazon. When replacing blown fuses, make sure to use the same ampere rating fuse. The fuse rating is written on the fuse.
What should I use when replacing a blown fuse?
When replacing blown fuses, make sure to use the same ampere rating fuse. The fuse rating is written on the fuse. You can verify that you are using the correct fuse, by making sure the fuse colors for the blown fuse and the new fuse match.