Why is my motorcycle making a clicking noise and wont Start?
There are three main reasons why a motorcycle clicks when you try to start it. The first and most common reason is because of a dead battery. The second reason could be due to a bad starter. The third most common but less likely reason the motorcycle is clicking could be due to a seized engine.
What are the symptoms of a faulty Yamaha Virago starter?
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
Why does my Virago make a clicking noise?
Starter Makes a Clicking Noise: Some users report that Virago’s starter will emit a clicking sound but won’t turn over. Other weird noises that show starter problems include a grinding, whirring, or buzzing noise. III. Starter Slips and Doesn’t Turn the Engine:
Why does my Yamaha Virago bike keep stalling?
In worse cases, riders have experienced a stall when the bike cuts out completely. The likeliest factor responsible for the running problems is an unkept fuel system. Viragos bikes have been around for a long time.
Is the Yamaha Virago a good bike to buy?
It proved attractive to riders as it was easy to ride and offered decent performance. If you are looking for a trusty cruiser with laid-back behavior, the Virago is an attractive option. But you’re here because you’re wondering if these bikes have any common problems and, if so, how severe they are.
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
What is the power relay on a Yamaha Virago?
When security percautions are satisfied: the sidestand is up and (gear in neutral position or clutch handle pressed) only then this relay will be activated and starter motor will be able to start the engine. The starter relay (solenoid) is big power relay.
How do you start a Yamaha Virago bike?
To start your Virago you: turn the choke on (cold starting only), make sure the bike is in neutral, turn the key to the on position, turn the kill switch to the on position, using one finger push the starter button. If your engine is tuned properly, it will start in less than three revolutions.
What should I do about my Virago 750 starter?
The XV-700’s and 750’s require a different repair because they do not have the starter clutch. Yamaha suggests changing the large tension clip, P/N 904-68291-06-00, on the idler gear.