What kind of carburetor did a Honda Trail have?
Honda’s 1970 CT-series, consisting of the Trail 70 and 90, were small single-cylinder motorcycles that were intended to be used both on and off of paved roads. Both motorcycle styles used a simple carburetor to provide a combustible mixture of air and fuel to the engine.
Where is the needle jet in a carburetor?
The needle jet—or nozzle as it’s sometimes called—is located in between the main jet and the carburetors venturi. Fuel comes through the main jet and into the needle jet. So the main jet does affect the needle, especially as the throttle opening increases. The needle is attached to the slide and slides up and down within the needle jet.
Where does the fuel go in a Mikuni carb?
Fuel comes through the main jet and into the needle jet. So the main jet does affect the needle, especially as the throttle opening increases. The needle is attached to the slide and slides up and down within the needle jet.
What should the CARB settings be on my Z50?
The stock carb settings from the factory are: middle clip, 1 3/8 turn out from full close for air screw, and no more than 3 full turns out from full closed on the throttle screw. I am usually able to get it idle at 2 1/2 turns, and fine tune from there.
Honda’s 1970 CT-series, consisting of the Trail 70 and 90, were small single-cylinder motorcycles that were intended to be used both on and off of paved roads. Both motorcycle styles used a simple carburetor to provide a combustible mixture of air and fuel to the engine.
How many parts does a Mini Trail have?
The Honda Z50A MINI TRAIL K1 1969 1970 USA has twelve Engine, thirteen Frame, six Other parts fiches. The largest parts list ( REAR WHEEL ) contains eighty-six products for this Z50A MINI TRAIL K1 1969 1970 USA.
The stock carb settings from the factory are: middle clip, 1 3/8 turn out from full close for air screw, and no more than 3 full turns out from full closed on the throttle screw. I am usually able to get it idle at 2 1/2 turns, and fine tune from there.
What should the idle speed be on a Honda Trailblazer?
Start the engine and let it idle in place for five minutes. Clamp an inductive tachometer over the spark plug cable at the top of the engine. The tachometer should indicate an idle speed of 1,300 to 1,500 rpm. Alternatively, listen to the engine to roughly estimate the idle rpm.