How do you bleed the brakes on a GSXR 1000?

How do you bleed the brakes on a GSXR 1000?

Bleed the brakes by pumping the rear brake pedal to build pressure, then hold it down, and open the valve with your wrench.

1. Repeat the process while continually topping off your reservoir as you pull fluid through.
2. Close the bleeder valve, then remove your hose and your wrench.
3. Top off the reservoir.

How do I change the brake fluid on my motorcycle?

How to change your bike’s brake fluid in 10 steps:

1. Time for a change? Look in your workshop handbook for the manufacturer’s recommended interval for fluid change.
2. Protect your paint.
3. Open the reservoir.
4. Tweak your nipple.
5. Crack and squeeze.
6. Top up with fresh fluid.
7. Watch for a colour change.
8. Check for air.

How often should you change brake fluid on a motorcycle?

As a general rule, the brake fluid level should be checked every 100 km or every month or so, and it should be changed around every two years.

How do you change a brake master cylinder on a motorcycle?

How do I rebuild the brake master cylinder on my motorcycle?

1. Step 1: Remove the master cylinder.
2. Step 2: Remove the rubber boot.
3. Step 3: Remove the circlip.
4. Step 4: Take out the piston and spring.
5. Step 5: Check and clean the cylinder.
6. Step 6: Fit the new seals to the new piston.
7. Step 7: Fit the new spring.

How do you change brake fluid on a Suzuki GSX-R?

Place the motorcycle on a level surface and keep the handlebars straight. Remove the brake fluid reservoir cap and diaphragm. Suck up the old brake fluid as much as possible. Fill the reservoir with new brake fluid. Connect a clear hose to the air bleeder valve and insert the other end of the hose into a receptacle.

How do you Bleed brake fluid on a motorcycle?

Step 1. Locate the brake fluid reservoir on the right side of the handlebar. Using a Phillips-head screwdriver, remove the metal bracket that holds the reservoir cap on. Step 2. Remove the reservoir cap by unscrewing it. Step 3. Get your 8mm wrench on the bleed valve, then attach a length of 3/16th hose to the bleed valve.

How can I get old brake fluid out of my car?

Suck up the old brake fluid as much as possible. Fill the reservoir with new brake fluid. Connect a clear hose to the air bleeder valve and insert the other end of the hose into a receptacle. Loosen the air bleeder valve and pump the brake lever until the old brake fluid flows out of the brake system.

How to replace brake fluid in Suzuki GSX are 1000?

Loosen the air bleeder valve and pump the brake lever until the old brake fluid flows out of the brake system. Close the air bleeder valve and disconnect the clear hose. Tightening torque air bleeder valve (front caliper): 7.5 N·m (0.75 Kgf-m, 5.5 Lbf-ft) Fill the reservoir with brake fluid to the upper mark of the reservoir.

Step 1. Locate the brake fluid reservoir on the right side of the handlebar. Using a Phillips-head screwdriver, remove the metal bracket that holds the reservoir cap on. Step 2. Remove the reservoir cap by unscrewing it. Step 3. Get your 8mm wrench on the bleed valve, then attach a length of 3/16th hose to the bleed valve.

Suck up the old brake fluid as much as possible. Fill the reservoir with new brake fluid. Connect a clear hose to the air bleeder valve and insert the other end of the hose into a receptacle. Loosen the air bleeder valve and pump the brake lever until the old brake fluid flows out of the brake system.