How do you change the CV joint on a Polaris Ranger?
Remove both the large and small boot clamps using boot clamp pliers. Slide the boot back so you can see the inside of the CV joint. Grip the splined end of the CV joint with one hand. Use your dead blow hammer to firmly hit the inner race and remove the CV joint.
What should I use to replace the U-joint on my ATV?
If you are going to replace the u-joint in your machine, you should pick the a Pro U-Joint Press Tool. It will make your job a whole lot easier and help prevent damage to the driveshaft. A good kit will include a wide variety of adapters to fit most any size you need.
How do you replace the CV joint on a Jeep Cherokee?
Use the grease packet included in your replacement boot kit to pack the CV joint with as much grease as you can. Place your replacement boot on the axle shaft in the same position and orientation as your stock boot. Place your new C-clip in the groove as well.
Can a torn CV boot on a Polaris Ranger be repaired?
When you find a tear, pick up a Polaris Ranger CV boot repair kit and fix it ASAP. There’s no reason to put off replacing a torn boot. It’s a small and cheap fix (SuperATV sells them for $25-$30) that can quickly turn into a more expensive fix if left unchecked. A torn boot can let water and dirt into the CV.
When to replace CV joint with Polaris CV boot?
These kits are a temporary trailside fix that don’t require disassembly of the CV joint to keep you riding; replace with a Polaris Engineered CV boot as soon as possible. For more maintenance procedures and pre-ride inspection procedures, consult your Owner’s Manual. Your comments are important for us.
What is part number for Polaris extra boots?
Extra boots are part number 2830529. These kits are a temporary trailside fix that don’t require disassembly of the CV joint to keep you riding; replace with a Polaris Engineered CV boot as soon as possible. For more maintenance procedures and pre-ride inspection procedures, consult your Owner’s Manual. Your comments are important for us.
How do you remove CV joint on Polaris Ranger?
Use your dead blow hammer to firmly hit the inner race and remove the CV joint. It is important that you use a dead blow or brass hammer and hit the inner race only. Hitting the outer race or using any other hammer can damage your CV joint. With the CV joint removed, remove the C-clip from the groove in the splines.
How do you replace a CV axle on a UTV?
the CV boot clamps. Pull the boots away from the CV joint and up the axle. axles are painted or powdercoated. Grasp the joint as shown and smack the CV joint with the dead blow or brass hammer. It will take a bit of force to drive the joint off the axle. Flip the other side. replace the parts that are damaged. Slide the boots onto the
Use the grease packet included in your replacement boot kit to pack the CV joint with as much grease as you can. Place your replacement boot on the axle shaft in the same position and orientation as your stock boot. Place your new C-clip in the groove as well.
How do you change the CV boot on a Polaris Ranger?
Make sure the small end of the boot rests in the groove and use your clamp pliers to clamp the boot to the shaft and the CV joint. Cut off any extra length of the clamp. And that’s how you change the CV boot on your Polaris Ranger!