How do I change my motorcycle key?
While it’s advisable to have a spare cut before you lose your original, there are ways to get a new key. A locksmith can use your bike’s ignition cylinder code or the entire ignition cylinder to make a new key. You also have the option of reordering a key from a local dealer, using your bike’s VIN.
What’s the best way to remove an ignition switch on a motorcycle?
To protect your bodywork put down clean rags and position your bike very safely and comfortably. Step 2) Begin with disconnecting the battery and removing the seat of the rider, in order to access the ignition area of the motorcycle easily.
How to remove Honda ignition cylinder easy way?
Remove Honda Ignition Cylinder (EASY WAY!) – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Can you replace ignition switch on Yamaha R-1?
When these are recovered, the ignition switch can be badly damaged and will need replacement. With the right tools, you can easily remove your ignition switch. These steps are specifically for the Yamaha R-1, but they can apply to other bikes as well. Just be sure to check your owner’s manual for any additional information you might need.
How do you remove gas tank from motorcycle?
Step 3) Remove the upper triple clamp by loosening the clamp bolts on each fork leg. By rocking back and forth, the clamp should lift off easily if everything is loosened correctly. Now remove the gas tank and disconnect all the hoses from the tank before you lift it and keep it aside.
How do you remove a broken key from an ignition lock?
Insert the tip of the pliers into the keyhole and then open them to spread the keyhole opening. There is no need to do this unless the broken piece of key is stuck, as it can damage your ignition lock/keyhole. Opening the keyhole will provide a clear path for removing the piece. Grab the broken piece of key with the pliers.
How do you lock the ignition on a Suzuki GS?
To get to inside of the lock, fthe irst you need to remove the headlight bucket to get to the ignition switch. Remove the two Allen-head bolts holding the housing with a 5mm Allen Wrench. Then lock remove the small screw that holds the actual electrical switch to the housing and you will end up lock with the whole shebang in your hand.
What do you do with ignition cylinder lock?
lock remove the small screw that holds the actual electrical switch to the housing and you will end up lock with the whole shebang in your hand. If you are not in a place that you can work on the cylinder, you can still start the bike by manually turning the switch to ON position with a coin and get to civilization.
How do you remove cylinder from Suzuki ignition?
First, remove the black plastic cover the top on and be careful not to break it as it is very brittle. To remove the cylinder from the lock system, you need to remove three -pins on the body roll of the lock housing.