Why is my Yamaha Venturer battery not charging?
If battery voltage is low, it should be charged before testing the charging system. A weak or defective battery may cause false test results. Have the battery tested or replaced if it will not achieve a full charge from a battery charger.
What to do if your Venturer battery goes bad?
Disconnect the connector and inspect the terminal pins for looseness, corrosion, or damage, and repair as needed. Regulator/Rectifier location. Check for battery voltage between the connector terminals marked Bat+ and Gnd- to insure those circuits are good. Be sure to inspect the condition of the connector terminals.
Where is the fuse box on a Royal Star Venture?
The Royal Star Venture has fuse boxes in three locations. Fuse Box \”A\” is located behind the right front lower cowling. To remove the cowling, remove the plastic retainer pin from ……
Where is the RSV Charger rotor located on a venture?
The RSV charging system uses a permanent magnet type AC Magneto (ACM) alternator. The stator and rotor of the alternator are located inside the left engine cover. The rotor is attached to ……
If battery voltage is low, it should be charged before testing the charging system. A weak or defective battery may cause false test results. Have the battery tested or replaced if it will not achieve a full charge from a battery charger.
Disconnect the connector and inspect the terminal pins for looseness, corrosion, or damage, and repair as needed. Regulator/Rectifier location. Check for battery voltage between the connector terminals marked Bat+ and Gnd- to insure those circuits are good. Be sure to inspect the condition of the connector terminals.
How does the Charger on a venture bike work?
The AC voltage produced by the alternator is converted to DC voltage by the Regulator/Rectifier (RR) which is mounted on the frame of the bike near the oil filter. The RR sends a regulated 14 volts DC to the bike’s electrical system and shunts excess voltage to ground. Charging System Specifications:
How can I access the RR connector on my venture?
Access the RR connector by removing the two 10mm RR mounting bolts and lowering the RR. ( Removal of the RF lower fairing makes it easier to access the RR bolts.) Disconnect the connector and inspect the terminal pins for looseness, corrosion, or damage, and repair as needed.
What does 14.5 volts mean on Yamaha Venture?
Higher than 14.5 volts indicates possible defective RR and/or poor connection. If the charging voltage is out of specs, check all connections in the system.