How long does it take to do torque check on Astra?
5 ) Re-cut thread before re-using and insert bolts with locking compound (red). Installation time including torque check must not exceed 10 minutes. 7 ) Assembly and disassembly with impulse or impact screwdriver is not permitted. Did you find the recommended reading relevant to this discussion?
How does the seat belt work on a Vauxhall Astra?
Seat belt Pull out the seat belt and engage in belt buckle. The seat belt must not be twisted and must fit close against the body. The backrest must not be tilted back too far (maximum approx. 25°). To release belt, press red button on belt buckle.
How is vacuum reservoir solenoid valve in Vauxhall Astra H?
Vacuum reservoir solenoid valve to vacuum reservoir bracket. 1 ) Use new nut (s). 2 ) Re-tightening to 8 Nm is required – observe tightening sequence.
How long does it take to install a Vauxhall Astra H?
Installation time including torque check must not exceed 10 minutes. 7 ) Assembly and disassembly with impulse or impact screwdriver is not permitted.
How to fix a Vauxhall Astra G engine?
Toothed belt – guide roller (exhaust side) to engine damping block support Ignition module to cylinder head (X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE) 1 ) Use new fastening bolts. 2 ) Use new fastening nut (s). 3 ) Recut threads before re-use and insert bolts with screw locking compound (red).
How much wheel nut torque does a Vauxhall Astra have?
Astra-J 2.0 CDTi. The handbook suggests doing them up to 140Nm. Hopefully not a typo? Seems a lot to me, considering most (if not all) of my previous Vauxhalls have been 110Nm. Can anyone confirm? Ta. Yep 140. Supposedly even the locker can take it, but I personally prefer to do the locker a bit less to avoid the risk of wrecking it. Thanks guys.
Where is the intake manifold on a Vauxhall Astra G?
Intake manifold flange to cylinder head (X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE) Engine vent flange to cylinder block (X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE) Oil dipstick guide tube bracket to exhaust recirculation adapter (X 18 XE1, Z 18 XE, Z 18 XEL) Fuel distributor pipe to intake manifold flange (X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE)
5 ) Re-cut thread before re-using and insert bolts with locking compound (red). Installation time including torque check must not exceed 10 minutes. 7 ) Assembly and disassembly with impulse or impact screwdriver is not permitted. Did you find the recommended reading relevant to this discussion?