How long should you crank a jump starter?
Crank for no more than 2-3 seconds at a time. Portable jump starters are designed to deliver short bursts of maximum power, so cranking for a long time will likely burn out the battery pack inside the jump starter. Once the bike starts, remove the negative clip first followed by the positive clip.
How do you jump start a motorcycle battery?
Connect the Jumper Cables as You Normally Would Attach one positive clip (red handles) to the positive terminal (usually has a red, rubber or plastic cover and labeled POS or +) of the dead battery. Attach the other positive clip to the positive terminal of the good battery.
How do you jump start a Harley Davidson Softail?
Locate the mounting nuts or bolt (s) around and under the seat. Remove them and gently lift the seat up. Look under the seat with a flashlight to identify any remaining mounting bolts. If your seat has a strap, you’ll most likely find one here. Pull the seat up and away from the gas tank. Figure 1. The battery charger connector. Figure 2.
Crank for no more than 2-3 seconds at a time. Portable jump starters are designed to deliver short bursts of maximum power, so cranking for a long time will likely burn out the battery pack inside the jump starter. Once the bike starts, remove the negative clip first followed by the positive clip.
What do you need to know about jump starters?
Jump starters are used by professional tow drivers, individual families, and parents driving their kids to school, so choosing the right jump starter for the job is crucial. Comparison shopping for the best jump starter online makes choosing the right one very easy, especially when you can look at them side by side and compare features.
How do you attach a jump starter to a bike?
Jump starter packs usually come with an assortment of attachments, but the most common ones are the familiar clips seen on traditional jumper cables. Connect the positive clip (red handle) to the positive terminal (labeled POS or +). Connect the negative clip (black handle) to a bare metal surface on the bike or the negative terminal.
Locate the mounting nuts or bolt (s) around and under the seat. Remove them and gently lift the seat up. Look under the seat with a flashlight to identify any remaining mounting bolts. If your seat has a strap, you’ll most likely find one here. Pull the seat up and away from the gas tank. Figure 1. The battery charger connector. Figure 2.