Is a ball joint an expensive fix?
In general, ball joints are inexpensive with a range between $20 to $80 each. Labor will vary greatly by model. Some vehicles cost as low as $60 to $80. Yet others, especially four-wheel drive trucks, can range from $160 to $200 per ball joint.
How do you replace a ball joint on a front wheel drive car?
Generally a job to replace ball joints will involve the following, but not exclusive to these steps: Taking off your vehicle’s wheels. Moving the brake calipers, and rotor. Some vehicles will need the sway bar links removed. Front wheel drive cars – in most cases, separate the lower control arm from the steering knuckle via a ball joint fork.
How many ball joints are there in a rear wheel drive truck?
In a traditional rear-wheel drive or full-size cars, there is an upper and lower ball joint on each side. Most trucks still take 4 ball joints. Ball joints fail the same way that tie rods fail.
Are there ball joints that can be replaced?
Some ball joints are built directly into the Control Arm and are not replaceable. Others are, either by being pressed, bolted, or riveted in. Most front-wheel-drive vehicles have only 2 lower ball joints on each side, as the upper pivot-point is accomplished by the strut assembly.
How many ball joints are there in a suspension?
On some newer design multi-link independent suspensions, there are two upper and two lower ball joints per corner, though this style is generally only replaceable with the whole control arms. A ball joint is just what it sounds like – a stud with a ball-end that’s trapped in a socket, so it can rotate and pivot and move relatively freely.
Where are the ball joints on a 4×4 truck?
For older or 4X4 trucks, most ball joints are pressed onto the axle, or onto the steering knuckle. In most cases, a ball joint press and ball joint fork will be needed to remove the ball joint and separate the control arm from the steering knuckle, which both of these are available for free through AutoZone’s Loan-A-Tool program .
Generally a job to replace ball joints will involve the following, but not exclusive to these steps: Taking off your vehicle’s wheels. Moving the brake calipers, and rotor. Some vehicles will need the sway bar links removed. Front wheel drive cars – in most cases, separate the lower control arm from the steering knuckle via a ball joint fork.
How much does it cost to replace ball joints on a Jeep Grand Cherokee?
For a 2000 Jeep Grand Cherokee four wheel drive, which uses a solid front axle, the labor time to replace the upper and lower ball joints on one front corner is 1.9 hours. A factory pair costs about $150, and a pair of Delphi ball joints costs about $63. This makes the job about $440 using OE parts, or about $353 using aftermarket parts.
How much does it cost to replace ball joint on Honda Civic?
For A 2003 Honda Civic, the labor time to replace the front lower ball joint is 2 hours. It’s pressed into the knuckle, which is usually removed for the service. A factory part costs about $65, or a Mevotech part costs about $35.