Why does my motorcycle Rev without the throttle?
When the throttle is applied it seems like it revs sometimes but not how a normal motorcycle would. The first thing I would do is check for proper operation of the throttle cables. Make sure they are returning to the proper location and not holding the throttle open by being gunned up or in a bind somewhere along their routing.
When do you need to replace a voltage regulator?
If your voltage reading is below 13.8 volts, you have a weak battery and will need to replace it soon. Read the schematics that came with the voltage regulator. In order to test a 3-terminal voltage regulator in electronic equipment, you’ll need to know which pins are the input, output, and ground pins.
What should the voltage be on a motorcycle Charger?
Rev the bike and the voltage should be at least in the 13’s at all engine rpm’s and go no higher than around 14.5v. If you are reading 15v or higher it is bad and means that the R/R is not regulating the extra voltage from the Stator and overcharging the Battery.
Where can I find a voltage regulator for my car?
There are 14 references cited in this article, which can be found at the bottom of the page. Voltage regulators are commonly found in vehicles and other electronic equipment. A voltage regulator will limit the maximum amount of voltage from a power source and prevents a device or alternator from shorting and overheating.
When the throttle is applied it seems like it revs sometimes but not how a normal motorcycle would. The first thing I would do is check for proper operation of the throttle cables. Make sure they are returning to the proper location and not holding the throttle open by being gunned up or in a bind somewhere along their routing.
If your voltage reading is below 13.8 volts, you have a weak battery and will need to replace it soon. Read the schematics that came with the voltage regulator. In order to test a 3-terminal voltage regulator in electronic equipment, you’ll need to know which pins are the input, output, and ground pins.
Rev the bike and the voltage should be at least in the 13’s at all engine rpm’s and go no higher than around 14.5v. If you are reading 15v or higher it is bad and means that the R/R is not regulating the extra voltage from the Stator and overcharging the Battery.
There are 14 references cited in this article, which can be found at the bottom of the page. Voltage regulators are commonly found in vehicles and other electronic equipment. A voltage regulator will limit the maximum amount of voltage from a power source and prevents a device or alternator from shorting and overheating.
Why is my motorcycle losing power when I turn it off?
Twist the throttle while the motorcycle is off; if the valves don’t completely open with a full throttle twist, extra slack on your throttle cable may be your problem. There is usually a tightening nut a few inches above the knob that connects to the carburetor at the end of the throttle cable.
Why do I lose power when I go to full throttle?
But I started noticing that when going at mid revs, as soon as I roll the throttle to full throttle, as soon as it it’s full throttle it seems to back off a bit. Could this be mechanic? Or just placebo me, expecting the bike to keep pulling harder and harder but I get to full throttle? Possible air/fuel ratio issue probably a dirty carb.
Why does my bike bog from quick throttle openings?
We’ll look at poor jetting in a minute, but let’s look at the other reasons why your bike bogs from quick throttle openings. An accelerator pump is simply a device (usually mechanical) on a 4 stroke carb that shoots an extra amount of fuel at low RPM throttle openings.
What to do if your bike Idles but bogs with throttle?
I will look during tomorrow times. If it idles fine but it bogs down with throttle, your high speed gas jet is probably clogged. Clean your carb and spray carb cleaner in all small passages, make sure air can flow through all ports no matter how small. Put it back together and it should run great.
What happens when you put the throttle on a motorcycle?
The bike revs it self pretty high. Not to redline but it gets up there. When the throttle is applied it seems like it revs sometimes but not how a normal motorcycle would.
Why does my bike Rev and go down?
Im planning on ordering a new cable as the casing on my current one is cracked which could cause some of the lack of tension. Also, it revs and goes down and revs again so it doesnt just rev and stay there. Click to expand… Your carbs are either dirty and gummed up, or you have a vaccum leak. Or both.
What causes a bike to stall at idle?
The slightest air leak would upset idle mixture and cause stalling or high idle speed that cannot be adjusted with the throttle stop screw. I’d look at some simple stuff first, like the spark plug – which might fire OK at idle, but misfires under throttle?