Can you take the ring off a speedometer?
Once you get 75-90% of the backside of the ring straightened out, you’ll be able to pop the ring off the front: Set it aside. With the ring removed you should be able to use your fingernails and pry the front, clear cover from the body of the speedometer.
Can a PTO cable be replaced on a speedometer?
Replace the speedo cable as well just to be safe. The speedometer is driven by a key from the end of the driveline to the driveline adapter. When the PTO bearing fails, the driveline drops, shearing the key. That is why people tell you to check the bearing.
Why does my speedometer quit working on my snowmobile?
There are other reasons a speedometer can quit; bad cable, bad speedometer adapter, bad speedometer head, but the most common problem is the sheared key caused by the bearing failing, which drops the drive shaft.
Can a dead speedometer on a Polaris be repaired?
If you have a “dead” speedometer of the newer version and would likely me to take a crack at fixing it (absolutely no guarantees about success!) then feel free to contact me via comments, below. Last year, a friend of mine had the battery go bad on his 1999 Polaris Sportsman 500 4-wheeler.
Once you get 75-90% of the backside of the ring straightened out, you’ll be able to pop the ring off the front: Set it aside. With the ring removed you should be able to use your fingernails and pry the front, clear cover from the body of the speedometer.
Why did my speedometer get too hot after the repair?
In testing the speedometer after the repair I applied 20 volts to it and the main regulator transistor soon got too hot to touch: If this had been a hot, summer day with the transistor crammed inside the waterproof speedometer casing with no free air ventilation, it would have been much hotter.
Why is the speedometer on my Polaris not working?
The speedometer is part of the electrical system of the vehicle and as such, it is possible that its malfunction – possibly due to a failed repair – could cause additional damage to other components.
Why is my presser foot not down on my sewing machine?
Presser foot is not down. You may be using incorrect foot. The feed teeth could be down, accidentally lowered ; Ensure that feed dog is in a raised position when sewing. On most machines you should be able to see the teeth rise about 2mm above the needle plate on forward movement.
Can a bad speedometer sensor cause you to slow down?
A malfunctioning speedometer sensor can also cause a speedometer to act erratically, fluctuating the reading from one speed to another; even though in reality you’re not speeding up or slowing down.
What should I do if my speedometer cable is failing?
In either case, a certified mechanic should be contacted immediately to inspect, diagnose and repair the problem. When a speedometer cable and housing are failing, they may make squealing noises. The noise is also associated with the speedometer needle jumping around erratically as we explained above.
Where does the noise from the speedometer come from?
The noise is also associated with the speedometer needle jumping around erratically as we explained above. The noises typically come from the dashboard of your vehicle, specifically where the speedometer is located. However, they might also come from the other source of attachment, the transmission under your car.
When to see a mechanic about your speedometer?
If you feel you are driving faster or slower than what the speedometer reads, it is a good idea to have your vehicle inspected by Your Mechanic, as this might be a problem with the sensor that can be repaired or an indication that the speedometer sensor needs replacement.