Can a grizzl-E be set up for 30 amps?
If you need to set up Grizzl-E for a 20, 30, or 40 Amp breaker, remove the front cover of the charger and adjust the DIP switches inside. For more information on how to do this please refer to the manual.
What kind of DIP switch does grizzl-E have?
Grizzl-E is an inexpensive non-smart EVSE with DIP switches inside the box to control the maximum output current.
Why is the green light on but no power?
I installed a new GFCI outlet with an one that was working. I wired it exactly as the older one and it isnt working. The green light is on but no power? I reversed the wires and no light. I replaced it back with the old one and it works…. I purchased a 3 pack of GFCI outlets and tried all 3 of them. None of them work but the old one does…
Why is the green light not flashing on my GFCI?
Some of the new GFCI’S need to be cycled to turn on the load If the green light is on solid not flashing the instructions say it is properly installed . the new GFCI’S are tough to reset my fingers have a tough time pressing in far enough and now use a tool.
How do you get a neutral light on a grizzly?
Try holding the rear brake in (either foot or left hand) and while pulling left on the gear lever, move forward and back to see if the light will come on in any position. Sometimes you need to adjust the “tie rod” which connects the shift lever to actual tranny shift point.
Why does my neutral light not come on?
Got a problem with the neutral light, sometime when placed in neutral it doesn’t come on and when you go to start it you need to engage the rear brake to start. Is this a common issue/problem?
How do you fix a bad neutral switch?
Turn on the key, if you get your green light it’s the neutral switch gone bad. Don’t be a moron like me and try to jump the wires with a test light. That won’t work. Keeping the wires jumped will get you a green light all the time.
Is there a neutral switch on a quad 300?
there is a neutral switch. Follow the blue wire from the reverse switch; rather than disconnect the neutral switch, bypass it. Jumper / short the blue wire to ground. The neutral light should lit up; if not, jumper / short the blue / black wire to ground; verify that it is not engaged in reverse.