Why is my starter rope stuck on my mini ATV?
Hi, so I started a DIY mini ATV project with a 49cc pocket bike engine about a year ago. I started it once, then it sat in my garage for a while. The other day, I tried to start it again. When I tried to start it, the pull rope came out a bit then got stuck. I tried to pull harder, but it wouldn’t move.
Why does the starter flywheel not turn when I push it?
The starter flywheel turned when I used a tool to push it. But as soon as I put the pull start assembly back on, it wouldn’t pull. Does anyone know what is wrong and how I could fix it? Thanks in advance! P.S I am only 13, so if the fix is obvious don’t judge. I don’t know much about this stuff. Answered! View the answer I have this problem too
What makes an ATV break down in a puddle?
From little metal shavings from engine wear to dirt and debris, the oil is a breeding ground for a break down. And if you’re playing in puddles with your quad, you might have a nice little water and oil mixture going on there, and you know what they say about oil and water: they don’t mix.
What happens when you put dirt on your ATV?
When dirt particles start invading the inner chambers of your quad’s powerplant, it won’t run as well as it should, which results in horsepower loss and interior damage to the engine, which can easily be fixed by buying a new engine (if that’s what you’re into).
What should I do if my ATV wont start?
If you have a carburetor, the most common fix is replacing the needle valve and seat. If you notice your spark plug is dry after trying to start the engine, that is a good indicator that you’re not getting fuel to the engine.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
What to do if your ATV float gets stuck?
Same thing will happen if your float is getting stuck. You’re going to need to clean the carburetor and possibly replace those parts if they’ve gone bad. First remove the float bowl to gain access to the carburetor insides. Then you can remove the pin holding the float in place.
Where are the recessed parts on a Kymco ATV?
Hold your key the same way and see if the recessed part is on the same side as your key Used on the MXU 150, MXU 250, MXU 270, MXU 300, Mongoose 250 and Mongoose 300 Fits: MXU 250, MXU 270, MXU 300, MXU 500, and Mongoose 300 Includes Ignition Switch, Gas Cap, Glove Box Latch and 2 sets of keys
What causes a Kymco MXU 300 not to start?
Fits: MXU 300 and Mongoose 300 2007 and older Bad Unit will prevent the ATV from running / starting (no spark at spark plug) Bad Unit will prevent the ATV from running / starting (no spark at spark plug) If this is broken your quad will not register neutral and will not start
Where are the blanks on a Kymco MXU 150?
Used on the MXU 150, MXU 250, MXU 270, MXU 300, Mongoose 250 and Mongoose 300 Kymco key blanks are cut two different ways (even for the same ATV) You must verify visually from the picture before ordering Hold your key the same way and see if the recessed part is on the same side as your key
What kind of parts do I need for my Kymco?
Don’t be fooled by other websites selling Kymco Parts Online, we strive to have these items IN STOCK and will ship next business day (in most cases). Fits: Mongoose 50, Mongoose 70, Mongoose 90 and MXer 150 (all years/versions)