How do I turn off the hazards on my Harley?
Turn the ignition key OFF and arm the security system if present and desired. The four-way flashers will continue for two hours. 3. To cancel four-way flashing, disarm the security system if necessary, turn the ignition key ON and press the left and right turn signal switches at the same time.
How do you put LED lights on a Harley Davidson?
Putting LED lights on a Harley Davidson usually requires that you install a load equalizer on the line. A load equalizer brings the load to the same level as two incandescent bulbs, so the system thinks that everything is okay. Check for a bad bulb: check all the bulbs for any burnt ends and replace them.
Why is my hazard light not working on my Harley?
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
How to test a Harley Davidson brake light switch?
Ok , so working out issues on this 1989 FLHTCU I fixed the brake lights , the wires in the left side panel had to be cleaned a soldered then they stopped working again. I did a repeat on the test light still had power to the wires at the switch on the rear.
What to do if no power to ignition or headlights?
And its the only thing left on the checklist that is in line to power the solenoid and headlights. Purchased an aftermarket ignition and spliced it in place of the old ignition switch. A starter relay was inexpensive so I purchased one just in case. I put the old starter relay back into the plug.
Why does my tail light keep turning off?
If the tail lights turn off, the switch is likely faulty and the light plug assembly might need to be replaced. Sometimes the problem is from faulty wiring. Replacing a wiring harness is a possible DIY job that entails cutting the old connector off, stripping and twisting the wires and connecting the new switch with a splice connector.
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
How do you reset the turn signal on a Dyna Glide?
Press left turn signal switch once, and light will flash a number of times to indicate an error code. There is 1.5 seconds between flashes to indicate 1st and 2nd digit of codes and four second pause between codes. Press and hold left switch down for five seconds, and light will flash twice to indicate the TSSM is reset. Turn ignition to off.
Putting LED lights on a Harley Davidson usually requires that you install a load equalizer on the line. A load equalizer brings the load to the same level as two incandescent bulbs, so the system thinks that everything is okay. Check for a bad bulb: check all the bulbs for any burnt ends and replace them.