What is the proper point gap for a 1977 FLH-ASAP?
point gap should be set to .018″ on the wide lobe, then checked on the narrow lobe for .016″-.020″. if the narrow lobe check is not within that tolerance, it indicates the point shaft bolt is bent. tap it back into alignment and repeat the setting procedure.
What kind of cigarettes does Katherine Heigl smoke?
Heigl once had a huge smoking problem, but she revealed on David Lettermanthat she now uses electronic cigarettes. Then she and David had a good laugh and a smoke together. Simon Cowell
What kind of cigarettes does Miley Cyrus smoke?
Miley Cyrus It’s no secret that Miley enjoys smoking. Cigarettes match perfectly with her wild girl image, but she allegedly indulged in cigs even when she was still brown-haired Miley. And, according to her Instagram, she’s quite the cannabis connoisseur as well.
What kind of smoke does a 2 stroke engine emit?
But you’re in luck if you’ve got a 2-Stroke. Those engines normally emit a blue/gray smoke. But if it’s excessive then you’ve got a burning oil problem, a rich fuel condition like noted above, a bad spark plug or a malfunctioning power valve.
Heigl once had a huge smoking problem, but she revealed on David Lettermanthat she now uses electronic cigarettes. Then she and David had a good laugh and a smoke together. Simon Cowell
Where does the smoke come from on a Honda 4 stroke?
On a 4-Stroke (usually Honda) the smoke typically blows out of the crankcase vent rather than the exhaust pipe. When faced with a smoke issue, don’t continue riding. Routine maintenance helps prevent many smoke related issues but old seals or gaskets and certainly a big crash can cause fluid leaks.
Miley Cyrus It’s no secret that Miley enjoys smoking. Cigarettes match perfectly with her wild girl image, but she allegedly indulged in cigs even when she was still brown-haired Miley. And, according to her Instagram, she’s quite the cannabis connoisseur as well.
What should the point gap be on a motorcycle?
Hi Jeff, point gap should be set to .018″ on the wide lobe, then checked on the narrow lobe for .016″-.020″. if the narrow lobe check is not within that tolerance, it indicates the point shaft bolt is bent. tap it back into alignment and repeat the setting procedure. let me know if you need more help. Steve Steve, Motorcycle Mechanic
What should the point gap be on a tooth?
point gap should be set to .018″ on the wide lobe, then checked on the narrow lobe for .016″-.020″.
What should the point gap be on a Haynes P1800?
The Haynes manual recommends a point gap of .016-.020 inches for engines used in the P1800. I used to set my points at exactly .018″, but they didn’t last long, and once I had to stop by the side of the road and file and reset them to get the engine running. Now I set them at .019″.
What should the gap be between ignition points?
When you can insert the .018″ gauge between the points without touching both of them, the gap is wide enough. To make sure it is not too wide, remove the .018″ gauge and insert the .020″ gauge. If the wider gauge can only be inserted touching both points, you have the correct gap.
Can a contact point gap be replaced in a car?
Setting the ignition contact point gap may eventually become a lost art, since the points are replaced in modern cars by electronic ignition. Even some owners of classic cars find it more practical to replace the points with an aftermarket electronic system.