Why does my Harley start without the key fob?
If they don’t the security system isn’t activated go to the dealer and have them activated. If they do flash and the bike will start without a fob then there is a fob somewhere on that bike.
What does a red key light on a Harley Davidson mean?
If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.
How do you turn off the hazard lights on a Harley Davidson?
How to turn the hazard lights off on a Harley Davidson? First, find out the hazard switch from the dash. Then, you need to press the hazard lights’ turn on switch to start the hazard lights. The four turn signals should flash by now. Finally, press the switch again to turn off the hazard lights.
How do you start a Harley Davidson engine?
Turn key to ignition,it starts,turn key slightly back a couple of mills and everything comes back on. So between ACC-IGNITION.I have connection. I also have digital clock display stand down,when it is up.
Why are my lights not working on my Harley?
your bike will not start because you have no IGNITION power. the ignition power runs the starter relay, coil and ignition module. the power source for lights and ignition are 2 separate switch contacts. your lights come off the keyswitch relay.
If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.
What’s the voltage on a Harley Davidson starter?
I check the voltage at the kill switch and get 12.3 from the black and white wire that goes to the kill switch and the start button. But, I only get 9.2 volts from the black and red wire from the start switch to the start relay. All the fuses are good and there are 12 volts to the starter and the solenoid.
How to turn the hazard lights off on a Harley Davidson? First, find out the hazard switch from the dash. Then, you need to press the hazard lights’ turn on switch to start the hazard lights. The four turn signals should flash by now. Finally, press the switch again to turn off the hazard lights.
Why is my starter not working on my Harley?
That black wire with the red tracer should be sending 12v to the starter relay. Be sure that this wire is not damaged or pinched anywhere in its travel. This will be more common when wires have been routed through the bars, or switch housings/switches have been changed. Don’t forget to use your multimeter inside the switch housings too.