What kind of ignition box do I Need?
I would like a 4 pin Dodge/Chrysler ignition “ECU” box from a 1983 pickup truck (example Dodge D-150 with 318 v8) – and the 2 pin ballast resistor that goes with it. I would like a 5 pin Dodge/Chrysler ignition “ECU” box from a 1975 pickup truck (example Dodge W-100 with 318 v8) – and the 4 pin ballast resistor that goes with it.
How can I tell if my ignition box is working?
If there is no sound check that the ignition box is getting correct voltage (Check the manual which terminal) If the voltage is much under 12V the ignition box will not sound “healthy”. If you have heard the sound while its working, you know the difference.
How does the distributor work in an ignition system?
In addition, while the battery and ignition coil provide the power, the distributor does an important job, that determining precisely where and when that power goes to each spark plug. The distributor decides precisely where and when that power goes to each spark plug.
Is the ignition system of a car still the same?
Although almost every major component of a car has undergone improvements through the years, the basic principles of the ignition system have not changed in nearly a century.
How does a digital 6A ignition box work?
When that switch is released, the low rpm limit is turned off and the car launches hard! The Digital 6A and 6AL Ignitions incorporate a secure and sealed connector for all of the wiring. This design routes the wiring out of one side of the ignition making wiring your engine easier and looks great.
I would like a 4 pin Dodge/Chrysler ignition “ECU” box from a 1983 pickup truck (example Dodge D-150 with 318 v8) – and the 2 pin ballast resistor that goes with it. I would like a 5 pin Dodge/Chrysler ignition “ECU” box from a 1975 pickup truck (example Dodge W-100 with 318 v8) – and the 4 pin ballast resistor that goes with it.
What does a MSD 6A ignition box do?
An MSD 6A Ignition will improve the overall performance of your engine thanks to its high output capacitive discharge sparks. Below 3,000 rpm the ignition delivers multiple sparks that will clean up the idle, improve starting and throttle response. Step up to the 6AL to have an engine saving rev limiter.
How does a 2 Step ignition box work?
The new 2-Step is digitally controlled and connects to the Digital 6AL’s gray tach output wire. There are two easy to read rotary dials that let you set the launch rpm in 100 rpm increments. There is an activation wire that connects to the transbrake, a clutch switch or to the line-lock to activate the low rpm limit.