How much oil does a Shovelhead take?
Recommended Fluids Harley-Davidson recommends 4 quarts of SAE 50 or 60 engine oil in all 1966 through 1984 shovelheads. The transmission uses 1.5 pints of HD transmission lubricant, although many people use 75w90 gear oil mixed 3-to-1 with Lucas oil.
Do Shovelheads have oil filters?
The Shovelhead engine, as produced up to 1981, relied on an in-oil tank filter element to keep debris from entering the engine. Unscrew the oil tank cap from the left side of the motorcycle, located directly below the rider’s seat.
What kind of brake fluid does a Harley Shovelhead use?
Models 1975 and later use Dot 5 brake fluid. The front fork oil capacity varied over the 18 years the shovelhead was in production. Instructions for new front forks include the amount of oil required. Models from 1966 to 1969 use 6.5 oz. of fork oil.
What kind of oil filter does a 1975 Shovelhead have?
Bought a 1975 Shovelhead a while back from a very shady character and among other things, when you start the engine, it starts puking tons of oil all over the floor. There is a braided metal line about 6-8″ long with a small filter on the end of it. Looks like a crank case breather line, on the right side of the engine.
How often do you change the oil on a Shovelhead motorcycle?
Motorcycles need their main fluids changed at regular intervals. That keeps the engine and other moving components lubricated and operating efficiently. The official maintenance recommendation is to change engine oil every 5,000 miles, but changing the oil at 2,500 miles is a good idea for an older shovelhead.
How do you check the oil level on a Harley Davidson?
Now, remove the dipstick/fill plug and view the oil level. The transmission oil level is correct when between the Add and Full marks on the dipstick. Checking oil on Harley is similar however there is the option to check the oil level on the kickstand or with the vehicle upright. Again, start with the motorcycle already warm.
How to check the oil level on a Harley Shovelhead?
Stop the engine and let the oil settle for another 10 minutes. Lift the motorcycle off of its side stand and into a level, upright position. Check the oil level by looking into the oil tank through its filler neck. Ideally, the oil must be 1 inch below the bottom of the filler neck.
Models 1975 and later use Dot 5 brake fluid. The front fork oil capacity varied over the 18 years the shovelhead was in production. Instructions for new front forks include the amount of oil required. Models from 1966 to 1969 use 6.5 oz. of fork oil.
Bought a 1975 Shovelhead a while back from a very shady character and among other things, when you start the engine, it starts puking tons of oil all over the floor. There is a braided metal line about 6-8″ long with a small filter on the end of it. Looks like a crank case breather line, on the right side of the engine.
When did the Harley Shovelhead engine come out?
The Shovelhead engine was introduced by Harley-Davidson in 1966 and was used until 1984, when it was replaced by the Evolution engine. The engine boasted a 1,340 cc displacement and Harley-Davidson’s classic 45-degree V-twin cylinder arrangement.