How do you change the oil on a virago?
While its not difficult to replace the filter and change the oil, a new Virago rider can be perplexed by the apparent lack of an oil filter. Lift the motorcycle onto its center stand, place it in neutral and start the motor.
Where is the oil filter on a virago XV250?
Remove the oil filter. The oil filter is fixed by three screws, one long one and two smaller ones, so it’s not easy to mix them up. The oil filter is located on the right hand side of the bike (note the previous photo for the location).
What kind of engine does a Yamaha Virago have?
As Yamaha’s first V-twin-powered cruiser motorcycle, the Virago has become a favorite for riders who prefer the bike’s classic lines and nimble handling. Although the Virago was available in a range of engine sizes, the 750cc model is the most commonly seen on the road today.
Why is there a screw in the drain plug on a virago?
The screw in the drain plug is used to stop the oil from draining out of your car during use. They chose a screw for this job because screws don’t easily slip out and are simple to use as opposed to some sort of complicated clamping system. Thanks! Include your email address to get a message when this question is answered.
While its not difficult to replace the filter and change the oil, a new Virago rider can be perplexed by the apparent lack of an oil filter. Lift the motorcycle onto its center stand, place it in neutral and start the motor.
Remove the oil filter. The oil filter is fixed by three screws, one long one and two smaller ones, so it’s not easy to mix them up. The oil filter is located on the right hand side of the bike (note the previous photo for the location).
How do you fix a leak in a virago engine?
Securely tighten the plug but avoid overtightening. Place the funnel into the hole where the filler cap was removed. Pour in the recommended amount of oil according to the manual for your Virago. Replace the filler cap and restart the engine. Look for leaks from the drain bolt area. If you notice leaks, turn off the engine right away.
Where is the site glass on a virago 1100?
Locate the site glass. It is under the starter and above the shift lever. If the reading shows at halfway or above, then you have enough oil. If not, you may want to follow the following steps to change the oil. Turn on the motorcycle again and let it run for a couple of minutes. This will help the oil drain more quickly. Turn off the engine.