What to do when your belt light keeps coming on?
Belt light came on and bike went to limp mode. Checked the toggle switch in the cover and did the belt light reset procedure. Belt toggle switch was not tripped as it was still in on position. Still reset the light and switched the toggle switch back and forth a few times just to be on the safe side.
Why does my kvf360 reset belt light keep coming on?
Do not turn the ignition on with the CVT cover removed or the KEBC motor will spool out and prevent you from putting the cover back on (unplug the KEBC motor if you do). Note: A poorly connected battery can cause the light to repeatedly come on even if the switch doesn’t flip.
When to reset belt light on Kawasaki ATV?
However, the belt light may stay on after flipping the switch back to “ON”, or it may have come on automatically at 100 hours to get you to return the machine to the dealer for inspection even though the belt switch is not tripped. The following procedures will reset the light if the belt switch is not tripped.
Can a loose belt light cause power loss?
A flipped switch will cause a power loss. See further down page for location of the switch. 2003 650, Prairie 700 and BF650 SRA can also have their belt switches tripped by a loose belt. A tripped switch will cause loss of power. Adjust the belt and flip switch to the “ON” position (a loose belt flips it to off).
Belt light came on and bike went to limp mode. Checked the toggle switch in the cover and did the belt light reset procedure. Belt toggle switch was not tripped as it was still in on position. Still reset the light and switched the toggle switch back and forth a few times just to be on the safe side.
When does the seat belt warning light go out?
Seat Belt Warning Light Stays On Think of your seat belt as an electrical circuit. It’s an ‘open’ circuit when the best is disconnected and ‘closed’ when connected.The seat belt warning light should go out once you have securely buckled up and closed the circuit.
What’s the best way to reset a check engine light?
In such a case, it is highly recommended to check the codes with a scanner instead. Switching the ignition on and off is also one method of hard reset without disconnecting batteries. Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step.
Why does the Check Engine light keep blinking?
When the ECU ( engine control unit) detects a problem that it is unable to regulate, it then turns on the check engine light on your dashboard. This check light will either keep on glowing or will blink, depending on the nature of the fault. If the engine check is on regularly then it means that there is a problem but not an emergency.