How do you change drain plug on Harley Davidson?
*TIP* The OEM drain plug uses a hexhead wrench to remove it. Being located in a position that is difficult to reach and keep a firm grip on, the head is easily stripped. This plug has been replaced with an allen wrench bolt, much easier to keep an allen wrench firmly seated in the head and greater torque ability.
How do you remove oil from drain plug?
Clean up any residual oil around the drain plug with a shop rag. Remove the oil filter with the oil filter wrench. Wipe the faceplate on the oil filter mount to remove any old oil and road grime and to ensure the old gasket did not remain stuck to the faceplate.
Where is the oil held in a Harley Davidson Low Rider?
Harley-Davidson Lowriders use a built-in oil pan instead of the traditional remote-mount type oil reservoir. The pan is cast into the bottom of the engine case, and the oil is held in with a special bolt with an o-ring seal. Engine temperatures vary widely in air-cooled engines, leading to oil breakdown.
What kind of motor does a low rider have?
The Lowrider pictured in this article has the Evo motor. You will have the Evolution motor on your ’03. Consult your owner’s manual to be sure, but the transmission should not be much different. Only the heads have been changed, not the transmission. These directions should be very close to what you will find on your ride.
What kind of drain plug does a Harley Davidson use?
Adapters are available for some models. (The EZ-102 will fit drain plug size 5/8″-18 UNF) (On some models 2014 & on, use A-102 adapter due to recessed oil pan) EZ Oil Drain Valve : Replaces the standard oil drain plug, making oil changes easier, saving valuable time and expenses.
Clean up any residual oil around the drain plug with a shop rag. Remove the oil filter with the oil filter wrench. Wipe the faceplate on the oil filter mount to remove any old oil and road grime and to ensure the old gasket did not remain stuck to the faceplate.
How do you change oil in a Harley Davidson Low Rider?
Pour the oil into plastic jugs once the oil resevoir has stopped draining. Replace the plug in the oil pan. You only need to snug it up against the O ring, which is responsible for the seal. Before installing the new oil filter, pour a little oil onto the O ring seal and use your finger to lubricate the entire surface.
The Lowrider pictured in this article has the Evo motor. You will have the Evolution motor on your ’03. Consult your owner’s manual to be sure, but the transmission should not be much different. Only the heads have been changed, not the transmission. These directions should be very close to what you will find on your ride.