How do I reset my Yamaha r1?
Once displayed on the screen dIAG press both buttons on the dashboard (SELECT + RESET) at ~ 2 seconds.
How do you clear a Yamaha error code?
basically once you get into the diagnostic mode, scroll to code 62. then flip the kill switch off to on to back off. or visa versa. that will clear the stored codes.
How do you clear the codes on a Yamaha Apex?
Go to code 62. This will tell you how many codes were thrown. On 62 push your hand warmer toggle switch down. This will clear the codes.
How do you set the clock on a 2005 Yamaha r1?
Setting the Clock. Push ‘SELECT’ and ‘RESET’ buttons together for at least 2 seconds. When hour digits start flashing push the ‘RESET’ button to set the hours. Push ‘SELECT’ button and minute digits will start flashing. Push ‘RESET’ button to set the minutes.
How do I set the time on my r1?
- System settings. To change system settings press and hold. INFO/MENU.
- Set time/date. PLEASE NOTE: Manual time &
- Auto update time. Adjust how time and date is.
- Set date format. Adjust the on screen date format.
- Time. Adjust how the time and date are.
- Set 12/24 hour. In ‘Time’ menu, use ▼▲ to.
What is tors on Yamaha snowmobile?
TORS, or throttle override system, is a safety feature pioneered for use on high-speed Yamaha vehicles such as snowmobiles and ATVs, which use a pull-throttle cable system instead of a hard linkage.
How do you set the clock on a 2006 Yamaha r1?
What does tors mean on snowmobile?
How to erase an error on a Yamaha R1?
To erase the error from the system’s memory, go to line d62 and turn on the stop engine button on the right remote control. When entering the diagnostic mode, the display shows cell [d01]. Pressing the Select (upper) button, you need to go to the indicator [d60] (real-time self-diagnosis) and [d61] (error memory) and see the number next to it.
How to change the fault code on a Yamaha motorcycle?
Turn off the ignition, the engine stop button to put in the ON position. 2. Disconnect the fuel pump connector. 3. Simultaneously press SELECT + RESET on the dashboard and not let go. 4. Turn the ignition switch (button still hold) and wait for about 8 seconds until the dashboard inscription “dIAG”.
What does er-4 mean on a Yamaha R1?
Er-4 – error communicating with the dashboard; Turn off the ignition. Turn off the Start / Stop Engine button (red on the right remote). Press both buttons on the tidy and HOLD THEM. Turn on the ignition, hold the buttons after turning on the ignition for about 8 seconds.
What does 44 mean on a Yamaha R1?
44 – error of the values / data of the diagnostic / ignition system, – is diagnosed by the self-diagnosis line D: 60 – 00 indicates the normal state of the readings of the EEP-ROM; – 01 indicates a violation in the mixing 01 cylinder – 02 indicates a violation in the mixing 02 cylinder – 03 denotes a violation in the mixing 03 cylinder