What should you try to do first if the throttle cable is stuck?
Immediately squeeze the clutch lever, turn off the engine at the cutoff switch and apply the brakes. Correct. Squeezing the clutch will stop the motorcycle accelerating. Turning off the engine will stop it over revving.
Why does my motorcycle start then die?
But most likely is the carb. Swap out the pilot jet, install a new, clean air filter, change the oil and oil filter (if there is one) and see if it will start. Hard starting is a classic sign of valves needing shimming, as is dirty carb pilot. Do NOT clean the pilot jet, just change it out.
What do you do if your throttle gets stuck on a motorcycle?
If your throttle sticks to the open position while you’re out on a ride, apply the brakes and steer yourself to a place where you can stop. Pull the clutch and shift into neutral then turn off your motorcycle.
How do I get my throttle cable unstuck?
Pour penetrating oil into the cable (Photo 1). Grab the inner cable with pliers and work it up and down to loosen it. When the cable moves freely and all the penetrating oil has drained out, squirt silicone lubricant into the funnel to keep the cable sliding freely. Reinstall the cable (Photo 2).
Is it necessary to replace throttle cable on motorcycle?
The throttle cable may seem like a simple part of your bike, but it can keep you from riding if not properly maintained or replaced. Read as we take you through cable maintenance and install tips for a new ProX throttle cable.
Where to check throttle return on a motorcycle?
Check throttle return with the handlebars all the way to the left, centered, to the right, and halfway between center and full stop on each side. If the throttle does not completely return the cable may be binding, incorrectly routed, frayed, or corroded, which warrants further investigation.
How often should you check your throttle cable?
The throttle cable is a critical component to your bike’s function, but it’s often overlooked. Follow the guidelines below to make sure you’re not stuck with a malfunctioning throttle. Most service manuals suggest checking throttle operation after each race or every 2.5 hours of operation.
How do you adjust the throttle on a motorcycle?
Once the decelerator cable has been set, the accelerator cable is adjusted. The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters.
The throttle cable may seem like a simple part of your bike, but it can keep you from riding if not properly maintained or replaced. Read as we take you through cable maintenance and install tips for a new ProX throttle cable.
Why is throttle return not as quick as it should?
If you don’t hear anything such as these noises, or you just have a feeling that the throttle return is not as quick as it should be, keep reading and I’ll show you how to diagnose and remedy the situation. If you EVER notice any damage to a throttle cable, Never try to cut frays off or “rig” a throttle cable in any way.
Check throttle return with the handlebars all the way to the left, centered, to the right, and halfway between center and full stop on each side. If the throttle does not completely return the cable may be binding, incorrectly routed, frayed, or corroded, which warrants further investigation.
The throttle cable is a critical component to your bike’s function, but it’s often overlooked. Follow the guidelines below to make sure you’re not stuck with a malfunctioning throttle. Most service manuals suggest checking throttle operation after each race or every 2.5 hours of operation.