Why does my Kawasaki Prairie 360 keep running?
08 Kawasaki prairie 360.cuts out and back fires on 08 Kawasaki prairie 360.cuts out and back fires on excelleration. New gas.plug, new carb. read more Curtis B. Retired service manager
How do you clean a Kawasaki Prairie 360?
I use Yamaha carburetor cleaner. It mixes with water and you heat the solution on a hotplate until it’s almost boiling then soak the carburetor and jets for 10-15 minutes. Wash with water and blow dry.
What should I do if my Prairie 360 wont start?
Check the manifold and air boot for cracks. Make sure the air filter is installed and cover is on. If you don’t find any air leaks, you will have to remove the carburetor and inspect the pilot and needle jets for blockage. If you don’t find anything, then I would change the jetting.
08 Kawasaki prairie 360.cuts out and back fires on 08 Kawasaki prairie 360.cuts out and back fires on excelleration. New gas.plug, new carb. read more Curtis B. Retired service manager
I use Yamaha carburetor cleaner. It mixes with water and you heat the solution on a hotplate until it’s almost boiling then soak the carburetor and jets for 10-15 minutes. Wash with water and blow dry.
Check the manifold and air boot for cracks. Make sure the air filter is installed and cover is on. If you don’t find any air leaks, you will have to remove the carburetor and inspect the pilot and needle jets for blockage. If you don’t find anything, then I would change the jetting.
When did the Kawasaki 360 Prairie 4×4 come out?
This 360 4×4 has me stumped. The history of it: I picked it up from a relative who bought it new in ’03 and ran about two tanks of gas through it, if that. It’s sat in a heated, air-conditioned building with fuel in it since ’03. I bought it from him.
Why does my 360 Prairie cut out at full throttle?
At full throttle it cuts out. If I shut the fuel off and run it out wide open it will run clean as it’s running out of fuel. That tells me it’s rich. If I pull the airbox lid off, it will run clean wide open, although it’s lean in the midrange without the lid. I know it’s running rich on top.
Why is my Kawasaki Bayou klf300 ATV not working?
With the Simpson, you can see the voltage fluctuating. The Fluke can’t refresh that quick. #1 problem found: The Ignition key switch was bad. With the ATV being left out in the weather elements for basically 19 years, water/dirt got into the ignition key switch, caused undue resistance and the contacts inside severely pitted.