How big are the caps on a tappet golf cart?
Tappet caps come in sizes .106”, .114”, .124”, .134”, .144”. NOTE: To get the caps off you have to remove the cylinder.
How big are the valves on a golf cart?
Valve clearance for both intake and exhaust is .004 to .008 cold. Check with engine at TDC of compression stroke, make sure both valves are closed. Tappet caps come in sizes .106”, .114”, .124”, .134”, .144”. NOTE: To get the caps off you have to remove the cylinder.
Can you use magnaflux Carrillo connecting rods with bolts installed?
DO NOT MAGNAFLUX CP-CARRILLO CONNECTING RODS WITH BOLTS INSTALLED The CARRILLO connecting rod is a precision, high strength, quality connecting rod, which when properly installed and maintained, will perform flawlessly in today’s racing and highperformance internal combustion engines.
What are the specs for a kf-82 golf cart?
KF-82 Torque Specs 1 Cylinder Bolts: 16-18 ft lbs. Connecting Rod Bolts: 29-30 ft. lbs. 2 Flywheel Nut: 60-65 3 Spark Plug: 15-20 4 Crankcase Bolts: 14-16 5 Cylinder Head Shroud: 8-10 6 Engine Mounting Nuts: 25-30. Piston to Cylinder Clearance: .010 in. Bore Taper (top to bottom): .006 in. Bore Out of Round: .0022 in. max
Do you have to torque your rod bolts?
Torqueing your rod bolts without pre-determining the required torque to achieve the correct rod bolt stretch is not recommended. However if this is the only tightening method available to you, DO NOT EXCEED THE TORQUE AMOUNT INDICATED FOR YOUR BOLTS. NOTE: Your Crowerods are totally rebuildable.
How to determine the torque of a connecting rod?
STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end. STEP 2: Use the chart below to determine the recommended lubricant, rod bolt stretch and torque amounts.
KF-82 Torque Specs 1 Cylinder Bolts: 16-18 ft lbs. Connecting Rod Bolts: 29-30 ft. lbs. 2 Flywheel Nut: 60-65 3 Spark Plug: 15-20 4 Crankcase Bolts: 14-16 5 Cylinder Head Shroud: 8-10 6 Engine Mounting Nuts: 25-30. Piston to Cylinder Clearance: .010 in. Bore Taper (top to bottom): .006 in. Bore Out of Round: .0022 in. max
What are the specifications for Crower connecting rods?
Please read this entire page before starting to install your rods. STEP 1: Your Crower connecting rods came with a connecting rod specification tag. Check the tag to find the rod bolt part number used to fasten your connecting rods. Rod bolt length listed here is the measurement from under the head to the end.