How do you disarm a Harley Davidson alarm?
1. Select 5 digit code (1 thru 9) and record it on the wallet card in the owners manual. 2. With an assigned FOB present, turn IGN key ON – OFF – ON – OFF – ON 3. Press Left turn signal switch 2 times. 4. Press Right turn signal switch one time and release.
How do I disable my alarm on my bike?
You could have avoided all that trouble by just reading your owners manual as HogDreamer demonstrated above. If the bike is secure in an enclosed trailer or in your sight, tywrapping the FOB to the bike or just putting it in a saddlebag or windshield pouch would have been the simplest and easiest way to do it.
Can a security system disarm a bike?
Your security system will disarm the bike and it cannot be started without deactivating the system first. This applies to systems using the button type security fob only. See further down the page for later button less models.
How to turn off the alarm on a V-twin?
* Turn IGN key to ON and set OFF/RUN switch to OFF. * Turn IGN key to ACC. * Press both turn switches. Turn signals will flash once. * Turn IGN to OFF. The systen responds with 3 turn signal flashes. * With fob present, turn IGN to ON. * Set OFF/RUN switch to RUN to exit transport mode. This info is straight out of the owners manual.
Is there a way to disarm a Harley Davidson alarm?
Otherwise pressing both the signals just turns on your 4 way flashers. Also if you got a owners manual with the bike in the back of the book it has a couple of punch out cards telling you how to manually disarm as well as a card to tell you how to put the bike in transport mode for trailering. Are you sure the the security system is the problem?
Is there a way to disarm the skip alarm?
OK so the skip finally disabled the security system, Chopper thanks for the run/off switch advice. Jerryw618, I had to remove the brand new battery from the FOB and turn the key to the “accessory” position in order to get the system to disarm. Guess what?
Your security system will disarm the bike and it cannot be started without deactivating the system first. This applies to systems using the button type security fob only. See further down the page for later button less models.
How to disable alarm and / or replace hfsm?
By pressing the reset button once it will scroll through these. By pressing and holding the reset button for 5 seconds it will enter that section for those codes. 4). Press and hold the reset button for 5 seconds to check the code in the section you want. 5). Record the code and hit the reset button for the next code or until it says end.