What was the name of the 1993 Honda CB1000?
In 1993, Kawasaki and Suzuki had big, naked standards, the ZR1100 and GSX1100, with Yamaha offering the half-faired FJ1200; Honda had no model in that category. These nakeds were intended for the rider who liked a bit of wind in his face and was not interested in tearing around closed courses on track days.
What kind of suspension does a Honda CB1000 have?
Suspension travel at both ends was said to be 4.6 inches, enough to provide a pleasant ride. The rear wheel was an 18-incher with a 170/60 tire, the front, 18 inches and a 120/70. For braking purposes, there were two discs on the front with 4-piston calipers, a single at the back, with a 2-piston squeezer.
What’s the compression ratio on a Honda CB1000?
Four 34mm constant-velocity Keihin carburetors fed the cylinders, a good deal smaller than the 38mm carbs on the CBR version. And the compression ratio was lowered, too, from 10.5:1 for the CBR to 10:1 for the CB.
How do you rebuild a Honda CB750 carb?
Remove all hoses from the bowls and any fuel lines from the carbs. If your bike has the vacuum-assisted petcock on it (AKA Spawn of Satan or SOS), remove it, but keep all the tubes connected to it. Start with the carbs facing down – smaller diameter ends on the table, and choke plates facing you.
What are the screws on a Honda CB750?
Remove the eight 5mm screws holding the top/rear rail on. If reusing the screws, set them aside. If using new Allen-heads, toss these Phillips screws. Turn the carbs on their tops and remove the eight 6mm screws from the front rail (you may need a pair of Vice-grips® to loosen these).
Where are the fuel rail tubes on a Honda CB1000?
8© 2010 & 2013 – MacGregor Carb Cleaning Service might damage them. Set them aside where you can find them later. Place the fuel and accel pump rail tubes in your tray for cleaning. Note: if this is a CB1000 or CB1100 bank, there won’t be a fuel rail tube between 2 & 3.
What to do with a Honda dohc-4 carb?
Place the 2 choke plates in the small parts tray for later cleaning. Slide the choke shaft out and put with the other parts in the small-parts tray. Pull the 3 & 4 carbs apart and remove the fuel rail and accel pump tubes as well as the vent rubber tube.