What causes Harley stator to go bad?
Stators can fail for multiple reasons. The first and generally most overlooked cause is time. Everything wears out over time. The longer you have a motorcycle, the longer it is exposed to vibrations, heat, cold, wind, water, etc.
Why is my Harley Davidson Ultra Classic not starting?
I have a 2010 ultra classic with ABS. It is not starting. The battery voltage is 12.75 off the battery. When I turn the main switch on, I get a drop to 12.5, and when the kill switch is turned on, I get a drop to 12.38. The self test goes out and hit the start switch with nothing – no volt drop, no starter engage, no nothing. DEAD.
Why is my Harley Davidson battery not charging?
If the stator fails, your battery will no longer be charging when you’re riding your motorcycle. Often times, a short can happen in the windings around the stator. The insulation on the wires can wear down over time or a wire can break.
What happens if you have a bad voltage regulator on a Harley?
If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.
What should I do if my Charger regulator is not working?
Assuming your rectifier part of the unit is still working, you’ll see current flowing to your battery. You will see your battery voltage increasing because it has current flowing into it. If you suspect the regulator part of the unit is not working, you can set your multi-meter to the “DC Volts” setting, generally a 20-volt setting.
I have a 2010 ultra classic with ABS. It is not starting. The battery voltage is 12.75 off the battery. When I turn the main switch on, I get a drop to 12.5, and when the kill switch is turned on, I get a drop to 12.38. The self test goes out and hit the start switch with nothing – no volt drop, no starter engage, no nothing. DEAD.
What causes a Harley Davidson battery to go bad?
The most common cause of electrical problems on a Harley Davidson is the battery or the voltage regulator. Troubleshooting can be performed in any garage, and it saves on expensive service bills.
If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.
Why does my motorcycle battery charger not work?
Basically, this does not allow the regulator to send voltage to the battery any higher than 14.6 volts. If the stator fails, your battery will no longer be charging when you’re riding your motorcycle. Often times, a short can happen in the windings around the stator. The insulation on the wires can wear down over time or a wire can break.