Why is my starter turning backwards on my Honda?
I held the gears in with my hand and hit the starter button and noticed that it was trying to turn the engine counter-clockwise and naturally the starter drive wouldnt engage the flywheel. so it just spins freely Click to expand…
Why does the starter spin but not turn the engine?
If the large gear is spinning, removing the motor was a coincidence. Unless, somehow, the starter motor is running backwards. That could only happen if you reversed the brush connections after you cleaned them. Looking at the gears, does the large gear spin clockwise when the starter runs?
How does the starter turn on a motorcycle?
The starter fits into the first gear, which drives a second gear, called the idler. That idler gear turns the clutch gear. That means the direction reverses twice, so the starter should turn counter-clockwise as you look at the output end, same as the engine.
Which is the bigger gear in the starter?
The bigger gear should be the input side of the starter clutch, and engages the rotor through the half of the clutch mounted to the back side of the rotor.
If the large gear is spinning, removing the motor was a coincidence. Unless, somehow, the starter motor is running backwards. That could only happen if you reversed the brush connections after you cleaned them. Looking at the gears, does the large gear spin clockwise when the starter runs?
Why is my starter spinning but not engaging flywheel?
The mechanism to engage the flywheel is faulty, probably it is seized, or battery doesn’t have enough power to make the solenoid fully pull the mechanism (check battery charge). Hit the solenoid “moderately” with a mechanic hammer, one or two dry blows, if next crank try works, then the mechanism is getting seized and needs maintenance.
The starter fits into the first gear, which drives a second gear, called the idler. That idler gear turns the clutch gear. That means the direction reverses twice, so the starter should turn counter-clockwise as you look at the output end, same as the engine.
What to do if your starter won’t start?
if the flex plate teeth are shot you just might get it to go if you put a wrench on the crank and turn the motor by hand a bit. Presuming the teeth are bad in a spot but not all the way around. In any case make darn sure the battery is good before tearing into anything.