How to get and clear diagnostic trouble codes?
The display will show each DTC for 10 seconds, then automatically scroll to the next entry and continue to cycle through the faults. To manually cycle through the fault list, press the cluster SELECT/RESET button. To clear codes. Diagnostic trouble codes (DTC) will end with an “A” while the code is active.
What do I need to clear OBD2 code?
Here’s what you’ll need to do: Make sure your car is parked in a level area, then pop open the hood. Remove the (-) cable from the battery. You may need to use a wrench if it’s latched on tightly. Perform the same procedure, but with the (+) cable.
How to retrieve Subaru check engine light codes?
There two ways to retrieve subaru check engine light codes and they are: Mind you, you will have to be skilled for you to be able to retrieve Subaru check engine codes without a scanner. And that is why included video demonstration so you can have virtual demonstration of the steps.
How do you clear a code on a Mercedes Benz?
You can clear codes through the Climate control unit – Go to position 3 (just before starting the engine, when the instrument cluster is illuminated), then set the left temperature to HI and the right to LO, then press simultaneously REST and EC buttons until the air circulation lamp starts blinking.
How long does it take to clear a continuous memory code?
If all systems check out OK then you will get a code 11 or code 111 (All Systems Pass) Next you will get a 6-9 second pause, then a single flash (separator code) then another 6-9 second pause. Do not unplug anything yet or you will clear your continuous codes! The next codes to be displayed are your continuous memory codes.
You can clear codes through the Climate control unit – Go to position 3 (just before starting the engine, when the instrument cluster is illuminated), then set the left temperature to HI and the right to LO, then press simultaneously REST and EC buttons until the air circulation lamp starts blinking.
How do you clear diagnostic code on Harley Davidson Softail?
Press and hold the odometer button to clear the code, and then shut off the ignition to exit the menu. Repeat the process to check the other systems. For 2014 and later models, hold the odometer button down on the lift grip. Move the ignition switch to the ignition position.
How to retrieve trouble codes on your EEC-IV system?
Start the truck and let it run at 2000 RPM for 2 minutes to warm the sensors. Turn off the engine and reconnect the jumper between the STI and DLC Connectors. Wait 10 seconds between the time you shut the truck off until you start it again. Start the truck.