Can a 70989-98c work on a Roadking?
Fact: The 70989-98C modules will not work in place of the 70989-04 (requires a different speed sensor signal imput). 70989-98C will work in place or any module that ends with -97 or dash -98 (x). Fact: All switch sets for 1998-2013 Road Kings are also sold out and have been for several years.
Can you use cruise control on a road King?
To maintain clutch “lockout” for 2004 to 2006 Road King Police. This assumes that you still have the original police hand control with the RED switches on your bike . To maintain the clutch “lockout” feature on your Road King police, purchase cruise control kit 77198-07 from your Harley dealer.
Where do you get cruise control on a Harley?
To maintain the clutch “lockout” feature on your Road King police, purchase cruise control kit 77198-07 from your Harley dealer. Have the Harley dealer cut off the Molex connectors and install Duetsch brand terminal sockets on each of the 17 wires. The Harley part number for the terminals is 72191-94.
How to install a 2000 Road King bike?
Shown – 2000 Road King your bike may vary depending on the year 8 10 9 A B 11 8. Lower the bike down, place wood blocks under the transmission to support the transmission for removal of the swing arm. 1 9. Have a friend help while you remove the pivot shaft nut from left side of bike. 10. Remove lower shock bolts.
What kind of engine does a 1997 Harley Davidson Road King have?
The 1997 Harley-Davidson Road King’s engine is the result of the Harley engineers’ innovations with pushrods and fiddle-free hydraulic lifters to operate the V-twin’s two valves per cylinder. Fran Kuhn
How do you install an axle on a road King?
To install axles, remove the axle retainer plate (see diagram 13 pg. 7) and insert axle. Reinstall bolts, loctite and torque to 31 ft. lbs. TIPInstall center cap into wheel before mounting.
Shown – 2000 Road King your bike may vary depending on the year 8 10 9 A B 11 8. Lower the bike down, place wood blocks under the transmission to support the transmission for removal of the swing arm. 1 9. Have a friend help while you remove the pivot shaft nut from left side of bike. 10. Remove lower shock bolts.
How do you install a pulley on a road King?
Install 7/16” pulley bolts with lock washers provided apply red loctiteand torque the pulley bolts. Have friend help hold the center section of the rear end with a screw driver through a hole in the rotor and through one of the holes in the star plate.