How do you turn off the FOB on a Harley Davidson?
With an assigned fob within range, turn the ignition switch to IGNITION. Before the security system lamp goes out, turn the ignition switch to OFF. Within three seconds, simultaneously press both the left and the right turn signal switches. After the turn signals flash once, the system enters the transport mode.
What should I do if my ignition switch is fried?
Test your ignition switch with a multimeter. Make sure it is not fried. You should have one wire, either from your starter post, or from your battery positive post going to your main breaker (30 amp). Your main breaker should power your ignition switch. Your ignition switch should power your ignition breaker and your lighting breaker.
Are there any Harley ignition switches left in stock?
Only 11 left in stock – order soon. . . Only 13 left in stock – order soon. . Only 6 left in stock – order soon. . Only 9 left in stock – order soon.
How do you test a new ignition switch?
Make sure the new battery is not damaged. Charge it and have it load tested. Make sure the battery cables are good. Test your ignition switch with a multimeter. Make sure it is not fried. You should have one wire, either from your starter post, or from your battery positive post going to your main breaker (30 amp).
How to turn off the FOB on a Harley Davidson?
Here’s how to do it!! 1. Select 5 digit code ( each digit being a 1 thru 9) and record it on the wallet card in the owners manual. 2. With an assigned FOB present, turn IGN key ON – OFF – ON – OFF – ON 3. Press Left turn signal switch 2 times. 4. Press Right turn signal switch one time and release.
What happens when you push the start button on a Harley Davidson?
There’s a connector plugged into the top of the starter, green wire. Unplug the connector and probe it for B+ while pushing the start button. If it shows volts the start button is good. Then take a jumper wire from the battery positive terminal to that same connector plug on the starter, the starter should spin and engage the engine (crank over).
Where is the starter relay on a Dyna Glide?
Starter solenoid electrical connections. Another component to inspect is the starter relay, which is located in the electrical fuse box underneath the side cover on the left side of the motorcycle. Relays have the potential to go bad and prevent high current from reaching the starter.