What is the error code on an airconditioner?
The function is to self-diagnoisis airconditioner and express the troubles identifically if there is any trouble. Error mark is ON/OFF for the operation LED of evaporator body in the same manner as the following table. If more than two troubles occur simultaneously, primarily the highest trouble fo error code is expressed.
When to use an error code on an evaporator?
Error mark is ON/OFF for the operation LED of evaporator body in the same manner as the following table. If more than two troubles occur simultaneously, primarily the highest trouble fo error code is expressed. After error occurrence, if error is released, error LED is also released simultaneously.
When do I get an error code on my temperature sensor?
If more than two troubles occur simultaneously, the lower number of error code is displayed first. After an error occurs, if error is released, error LED is also released simultaneously. Indoor Unit Faults: Indoor temperature sensor open or closed circuit. Outdoor temperature sensor open or closed circuit.
What is the error code for an LG AC unit?
CH 07: Themostat Wiring Error. During operating Remote mode, if PTAC receives control commands that can not be drive from Themostat, Themostat error occurred. CH 09: EEPROM Check Sum Error. EEPROM Check Sum Error is occurred by unmatching between the original checksum and the calculated checksum. CH 10: Indoor Fan Error.
What to do if your Kenmore dishwasher has an error code?
Disconnect your dishwasher appliance from the mains. Wait for 5 minutes. Connect the machine to the mains socket again and restore the power supply. If the code returns, examine the wiring on the control unit for damage. Once you have revealed any broken wires, repair the connections.
What are the error codes for a Miele dishwasher?
Miele Dishwasher Error Codes. F00 – No fault registered F01 – Water/heating NTC or leads short-circuited F02 – Water/heating NTC or leads open-circuited F11 – Drainage fault F12 – Water intake fault at start of step F13 – Water intake fault at end of step F14 – Water intake fault: Heater pressure switch F15 – Water intake fault: Hot water
The function is to self-diagnoisis airconditioner and express the troubles identifically if there is any trouble. Error mark is ON/OFF for the operation LED of evaporator body in the same manner as the following table. If more than two troubles occur simultaneously, primarily the highest trouble fo error code is expressed.
Error mark is ON/OFF for the operation LED of evaporator body in the same manner as the following table. If more than two troubles occur simultaneously, primarily the highest trouble fo error code is expressed. After error occurrence, if error is released, error LED is also released simultaneously.