What causes idle issues on a V Star 650?
In addition to a sticking cable or throttle mechanism, that is sometimes caused by leaving the “choke” on too long or by an air leak around the carbs……assuming that it HAS carbs. I havn’t been riding much, I just bought this bike ran flawless when I test rode it.
When did the Yamaha XS650 bike not start?
Discussion in ‘ The Garage ‘ started by inxs, Jan 16, 2010 . Bike wont start?, Running rough? First: What have you just done? What have you changed?
Why does my VStar 650 not change gears?
I have a vstar 650 its a 2007. When I pull the clutch in to change gears motor revs. The throttle does not seem to be sticking, bike is warmed up, just seems to take time for it to return to an idel when I rev it or as stated am in the process of shifting. Any help would be appreciated.
What’s the best choke for a V Star 650?
Berrymans B12 Chemtool and Gumout are good ones……..and are usually available at auto parts stores and WalMart…….for about 1/3 the price of the “miracle snake oil” product. Yes, the choke works as it should. It is always required when starting the bike cold.
In addition to a sticking cable or throttle mechanism, that is sometimes caused by leaving the “choke” on too long or by an air leak around the carbs……assuming that it HAS carbs. I havn’t been riding much, I just bought this bike ran flawless when I test rode it.
Is the Yamaha V Star 650 in production?
For the current model year, the 650 is not in production, but Yamaha does have a 2020 and 2021 VStar 250 available. Yamaha also offers Star touring bikes, but again not in the 650. With so many model years there are plenty of used bikes to search through, although availability is dependent on the local market.
Is the Yamaha 650 touring bike in production?
For the current model year, the 650 is not in production, but Yamaha does have a 2020 and 2021 VStar 250 available. Yamaha also offers Star touring bikes, but again not in the 650.
What should I do if my Yamaha XS650 wont start?
– install new plugs, gapped, N7Y champion or BP7ES ngk 0.027-0.031″ (0.7-0.8mm) – if you have points, check the advance mechanism, pull the rod, clean and lubricate it, check the weights, make sure they move freely and arent loose, check the springs-the weights should snap back fully, if not shorten the springs-even better replace… video atu
Is there a rev limiter on a V Star?
Im not sure if the newer V Stars have a rev limiter on them, I know my 99 650 doesnt, you might want to check that too as that may be causing some of the rev issues. Im not totally convinced this is a fuel related issue. Sounds more mechanical than anything else. You could also try replacing your clutch springs as well.
I have a vstar 650 its a 2007. When I pull the clutch in to change gears motor revs. The throttle does not seem to be sticking, bike is warmed up, just seems to take time for it to return to an idel when I rev it or as stated am in the process of shifting. Any help would be appreciated.
Berrymans B12 Chemtool and Gumout are good ones……..and are usually available at auto parts stores and WalMart…….for about 1/3 the price of the “miracle snake oil” product. Yes, the choke works as it should. It is always required when starting the bike cold.
Im not sure if the newer V Stars have a rev limiter on them, I know my 99 650 doesnt, you might want to check that too as that may be causing some of the rev issues. Im not totally convinced this is a fuel related issue. Sounds more mechanical than anything else. You could also try replacing your clutch springs as well.
Why does my motorcycle engine stall when warm?
And the problem is often worse on a hot day. The dreaded stalling issue when the engine is warm is the most common idle problem and it is mostly related to the very lean air/fuel ratio on the modern fuel injected motorcycle engine. Why does my motorcycle stall at idle when the engine is warmed up and at operating temperature ? – Low compression.
Why does my V Star 250 not start?
Recurrent Starting Problems Some V Star 250 owners have reported experiencing starting problems on their bikes. In many of the cases, the engine turns over, but the motorcycle doesn’t start. In other cases, the engine won’t turn over, and the bike won’t run at all.
Can a bad throttle position sensor cause idle surging?
Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light
Is the warrior Idles fine when trying to accelerate?
The warrior idles fine. I’ve adjusted to air mix screw back and forth. It changes the idol but doesn’t seem to improve things when I try to rev it up. 2.25 turns seems to be the sweet spot, as far as idol. The needle is where zoom put it.
Why does my Raptor idle when trying to accelerate?
Sounds like the accelerator pump isn’t working, or pilot is partially plugged, or air mixture is too lean. May be a combo of several of those things. When my sons Raptor was doing that, it was because the pilot was too small, then had to tweak the air mixture to get it just right.
What to do if your bike Idles when trying to accelerate?
Clean the carb,run some sea foam through it,if that doesn’t work,try your timing.if all else fails it could be a sticky valve and or a bent valve ( I ran a bike on a bent valve for 2 months before it blew) How do you check the valves. I’m not a mechanic but I can do the small stuff. Lol I have a 89 warrior. I put it in the shed during deer season.
What kind of bike starts but does not Rev?
Check it out! Enjoy XS650.com? Consider making a donation to help support the site. my bike starts,runs,idles perfectly but will not rev! Discussion in ‘ The Garage ‘ started by mouser, Aug 17, 2011 . I have an ’80 with 38mm carbs from a ’76. I have owned an XS since 1977. I have never had anything like this happen.